La Crosse Technology WT-3129Sx1 User manual

12” ATOMIC WALL CLOCK
Model: WT-3129Bx1 / WT-3129Sx1
DC: 112018
For information about WWVB, Atomic Time Signal visit:
bit.ly/AtomicTime
• Always purchase the correct size and grade of battery most suitable
for intended use.
• Clean the battery contacts and also those of your clock prior to
battery installation.
• Ensure the battery is installed with correct polarity (+ and -).
• Remove battery from your clock when it is not used for an extended
period of time.
• Promptly remove an expired battery.
CARE AND MAINTENANCE
Battery Requirements: 1 AA (IEC LR6) required in movement
(Alkaline recommended)
Optional: 2 AA batteries
Battery life: 1 battery: 12 months / 3 batteries: up to 36 months
SPECIFICATIONS
La Crosse Technology, Ltd. provides a 1-year limited time warranty (from
date of purchase) on this product relating to manufacturing defects in
materials & workmanship.
Before returning a product, please contact our friendly customer
support with questions or visit our online help.
Phone: [phone]
Or fill out our online support request form here:
bit.ly/contact_techsupport
WARRANTY AND SUPPORT
Page | 1Page | 4
WARNING: This product can expose you to chemicals including styrene,
which is known in the State of California to cause cancer.
For more information go to: www.P65Warnings.ca.gov

POWER UP
1. Select Time Zone and DST ON or OFF.
2. Insert 1 AA battery into the Center Battery Compartment.
OPTIONAL: Insert 2 AA batteries into the Side Battery
Compartments for an extended 3 year battery life.
IMPORTANT: Be sure all batteries are of the same voltage level.
3. For best reception, place your clock on a wall that faces Ft.
Collins, Colorado. During the night, your clock will set itself.
IMPORTANT:
• Hands will move to 12:00 and search for the Atomic Time Signal.
• If no signal, after 8-10 minutes, clock will run from 12:00.
• Clock will continue to search for the WWVB Atomic Time Signal.
• Allow up to 5 nights for the clock to receive the Atomic Time
Signal.
6
5
SET
RESET
WAVE (Atomic search)
Center Battery Compartment
Time Zone Selector
Daylight Saving Time Selector
Set Time:
1. Hold SET for 3 seconds
2. Press and Hold SET to move hands quickly.
3. Press and release SET to move hands forward step by step.
Note: The atomic time signal will override manual settings.
Reset:
• If the clock does not respond when trying to manually set
your time, press the RESET button on the movement case.
4
3
2
1
6
5
4
3
2
1
MANUALLY SET TIME
• In certain areas, your clock may not be able to receive the
Atomic Time Signal. due to signal strength or interference.
• In this case, your clock can be set manually and operate as a
quartz clock until the WWVB signal can be received.
Follow us on our social media outlets for the latest promotions,
product support, and awesome giveaways.
LET’S BE SOCIAL!
Page | 3Page | 2
Side Battery
Compartment