La Crosse Technology 308-1409B User manual

Model: 308-1409B/308-1409W
Instruction Manual
DC: 121815
Wireless Temperature Station
Get Started
1. Insert 2 new AA, Alkaline batteries into the TX141-Bv2 sensor.
LED
TX Button
AA
AA
2. Insert 2 new AAA, Alkaline batteries into the station. Observe
the correct polarity.
3. Allow sensor and station to remain 5-10 feet apart for 5 minutes
to lock in the sensor signal.
4. After 5 minutes place sensor outside in a shaded location.
AAA
AAA
LO/HI/CLEAR °F/°C/SENSOR

Select Fahrenheit or Celsius
• Press and release the °F/°C/Sensor button to switch between
Celsius or Fahrenheit temperature display.
HI/LO Temperature Readings
• View: Press and release the LO/HI/CLEAR button to view outdoor
and indoor LO temperatures, then HI temperatures, then current
temperatures.
• Reset: While viewing LO or HI temperatures, hold the
LO/HI/CLEAR button for 5 seconds to reset to current
outdoor or indoor temperature.
Outdoor Sensor Search
• Hold the °F/°C/Sensor button for 3 seconds to search for the
outdoor sensor.
• If the signal is lost, station will display the LAST DATA recorded for
10 minutes, after that 10 minutes if the signal does not come back
then the station will display dashes “--”.
• After 30 minutes, station starts looking for the sensor automatically.
308-1409B/308-1409W www.lacrossetechnology.com/support Page | 1
LO Temps
HI Temps
OR
OR
OR

Low Battery Icons
• Low battery icon near outdoor temperature, change batteries in the
outdoor sensor.
• Low battery icon near indoor temperature, change batteries in the
temperature station.
Specications
Indoor Temp Range: +32°F to +122°F (0°C to 50°C)
Outdoor Temp Range: -40°F to 140°F (-40°C to 60°C)
Distance: Over 300 ft. (91 meters) RF 433MHz (open air)
Power Station: 2-AAA, IEC, LR3 batteries (not included)
Power TX141-Bv2: 2-AA, IEC, LR6 batteries (not included)
Battery Life Station: over 12 months with reputable batteries
Battery life TX141-Bv2: over 24 months with reputable batteries
Dimensions Station: 2.64” W x 1.38” D x 3.66” H (66 W x 35 D x 93 H mm)
Dimensions TX141-Bv2: 1.57”W x 0.82” D x 5.11” H (40 W x 20.8 D x 129.8mm H)
• Mount the Outdoor Sensor on a north-facing wall or in any well
shaded area. Under an eave or deck rail is preferred.
• The maximum wireless transmission range to the station
is over 300 feet (91 meters) in open air, not including walls or oors.
• Be sure the outdoor sensor is mounted vertically.
Position Outdoor Sensor
Warranty and Support
La Crosse Technology, Ltd. provides a 1-year limited time warranty (from date of
purchase) on this product relating to manufacturing defects in materials & workmanship.
Before returning a product, please contact our friendly customer support with
questions or visit our online help:
Phone: [phone]
Online Product Support:
www.lacrossetechnology.com/support
Product Registration:
www.lacrossetechnology.com/support/register
View full warranty details online at:
www.lacrossetechnology.com/warranty_info.pdf
Warranty Address:
La Crosse Technology, Ltd
2830 S. 26th St.
La Crosse, WI 54601
Protected under U.S. Patents: 5,978,738 | 6,076,044
Page | 2 www.lacrossetechnology.com/support 308-1409B/308-1409W

This equipment has been tested and found to comply with the limits
for a Class B digital device, pursuant to part 15 of the FCC Rules. These limits are
designed to provide reasonable protection against harmful interference in a residential
installation. This equipment generates, uses and can radiate radio frequency energy and,
if not installed and used in accordance with the instructions, may cause harmful
interference to radio communications. However, there is no guarantee that interference
will not occur in a particular installation. If this equipment does cause harmful
interference to radio or television reception, which can be determined by turning the
equipment off and on, the user is encouraged to try to correct the interference by one or
more of the following measures:
• Reorient or relocate the receiving antenna.
• Increase the separation between the equipment and receiver.
• Connect the equipment into an outlet on a circuit different from that to which
the receiver is connected.
• Consult the dealer or an experienced radio/TV technician for help.
This device must not be co-located or operating in conjunction with any other
antenna or transmitter.
Operation is subject to the following two conditions:
(1) This device may not cause harmful interference, and
(2) This device must accept any interference received, including interference
that may cause undesired operation.
Caution!
The manufacturer is not responsible for any radio or TV interference caused by
unauthorized changes or modications to this equipment. Such changes or
modications could void the user authority to operate the equipment.
All rights reserved. This manual may not be reproduced in any form, even in part, or
duplicated or processed using electronic, mechanical or chemical process
without the written permission of the publisher.
This booklet may contain errors or misprints. The information it contains is
regularly checked and corrections are included in subsequent editions. We disclaim any
responsibility for any technical error or printing error, or their consequences.
All trademarks and patents are recognized.
Canada Statement
This device complies with CNR Industry Canada license -exempt devices. Operation is
subject to the following two conditions:
(1) This device may not cause interference; and
(2) This device must accept any interference, including interference that may
cause undesired operation of the device.
FCC Statement
• Do not mix old and new batteries
• Do not mix Alkaline, Standard, Lithium or Rechargeable Batteries
• Always purchase the correct size and grade of battery most suitable
for intended use.
• Replace all batteries of a set at the same time.
• Clean the battery contacts and also those of the device prior to
battery installation.
• Ensure the batteries are installed with correct polarity ( + and - ).
• Remove batteries from equipment which is not to be used for an
extended period of time.
• Remove expired batteries promptly.
Care and Maintenance
308-1409B/308-1409W www.lacrossetechnology.com/support Page | 3