CONNECT LIGHT BAR TO POWER SUPPLY
96 WATT POWER SUPPLY
CONNECT LIGHT PANEL
TO LIGHT BAR
WIRED SIDE OF LIGHT PANEL
UPPER SIGN CHANNEL
ROUTE WIRES THROUGH HOLES
SECURE POWER CORD TO HOLES
AT BACK OF CORNICE WITH A CABLE TIE
LIGHTING INSTALLATION
NOTE! EACH 96WATT POWER SUPPLY WILL POWER 2 SECTIONS OF CORNICE. OVERLOADING WILL CAUSE PREMATURE FAILURE OF POWER SUPPLY
STEP 1: INSTALL POWER SUPPLY INTO TRAY OF 1ST CORNICE.
STEP 2: CLIP 48"LIGHT BAR ONTO CLIPS AND ATTACH BARREL PLUG TO POWER SUPPLY
STEP 3: INSERT SIGNAGE FROM SIGN KIT INTO FRONT CHANNELS OF CORNICE BEFORE INSTALLING PANEL LIGHT. SIGNAGE INSTALLS SAME AS LIGHT PANEL.
STEP 4: TO INSTALL LIGHT PANEL, INSERT WIRED SIDE OF PANEL INTO THE UPPER SIGN CHANNEL OF CORNICE AND THEN LOWER LIGHT PANEL INTO BOTTOM CHANNEL.
STEP 5: CONNECT BARREL PLUG ON LIGHT PANEL TO REMAINING BARREL PLUG ON LIGHT BAR.
STEP 6: FOR 2ND CORNICE, FOLLOW STEPS 2-5 EXCEPT ROUTE END BARREL PLUG THROUGH HOLES IN BRACKET AND ATTACH TO POWER SUPPLY IN FIRST CORNICE.
STEP 7: ENSURE EXCESS WIRING IS TUCKED AWAY IN REAR TRAY. NOTE! LIGHT PANEL WILL NEED TO BE REMOVED FOR FUTURE SIGN CHANGES. ENSURE CABLES
HAVE SLACK TO ALLOW LIGHT PANELTO BE REMOVED. CABLES CAN BE SECURED TO TRAY WITH A CABLE TIE.
REV.
PAGE
LAD DESCRIPTION
LAD PART NO.
MOVIE CORNICE W/ LIGHT 1848
2 OF 2
Customer Service 1-800-682-5730
2
BY
DATE
RP
04/25/18
20203800IS
