Lake Shore FF417 User manual

All Around Dress-Up Center
Follow these directions to assemble your new dress-up center. All you’ll need is a Phillips screwdriver; we’ve
provided all of the hardware. Because the pieces are bulky, you’ll need another adult to help you.
Hardware
Assembly Instructions
mirror panel (A/F)
base
bottom
Position the mirror panel (A) between
the raised bars on the bottom. Then
place the other section panels on the
bottom. (When the panels are posi-
tioned together, A& Bwill create one
section, C& Dwill create the section for
the shelves, and E& Fwill create the
section for the hooks.) Make sure that
the pilot holes for the hooks are posi-
tioned toward the top of the panels.
1” large round head
screws (6) I
1
11⁄2” round head
screws (28) H
Holes at top
for hooks
What’s Included
top
hook panel (D/E)
shelves (4)
hooks (10)
©2009 Lakeshore FF417
[phone] Ages 3+
www.lakeshorelearning.com Printed in China
1
1” small round head
screws (20) G
shelf panel (B/C)

A
Position the shelves in place, starting at the
bottom of the panels (C& D). Insert one of the
flat head screws (H) through the outside pilot
hole and into the shelf. Do not tighten the
screw completely. Repeat with the rest of the
shelves.
2
Turn the unit upside down. Use a screwdriver
to secure the (H) screws through the bottom
and into the section panels.
4Place the base onto the bottom of the unit.
Important: line up the guide hole in the base of
the unit with the pilot hole marked Aon the lazy
Susan. Then, line up this pilot hole with the pilot
hole in the bottom of the unit also marked A.
Please note that the base and the bottom of the
unit will not connect correctly unless both pilot
holes marked Aare in line with one another.
Insert an (I) screw and tighten with the screw-
driver. Rotate the guide hole to the next hole and
repeat.
Helpful hint: After you’ve aligned the two pilot
holes marked Aby sight, use the (I) screw as a
guide to make sure that both holes connect
together.
5
Place the top of the unit onto the panels.
Secure the top of the unit with 6 (H)
screws. Then, insert the remaining screws
for the shelves and tighten.
3
2

Once the base is secured, place the center back
in the upright position.
6
Remove the protective cover from the mirror.
89
Position a hook over the pre-drilled pilot
holes and insert 2 (G) screws. Use the screw-
driver to tighten the screws securely. Be sure
not to overtighten the screws. Repeat for the
remaining hooks.
7
That’s it! Your All Around Dress-Up Center is ready
to use!
3