•
• Keep all ventilation slots clear of obstructions, as this may cause
premature failure of the oven element.
• Parts of the appliance may become hot during or immediately after use.
Care should be taken to avoid touching the heating elements, and
components inside the oven which maybe hot. Always allow sufficient time
for the oven to cool.
• Do not allow the oven to cool with the door open. Even if the appliances
door is only open a little, front panels of adjacent units could become
damaged over time.
• If the door seal is very dirty this can prevent the door from closing properly
during use, resulting in possible damage to adjacent furniture and poor
efficiency. Always ensure the door seal is clean.
• Always use heat resistant oven gloves when putting dishes in or removing
dishes from the hot oven.
• Do not use the product if any door glass is removed or damaged.
• Rear surface of the oven may get hot when it is in use. Make sure that the
electrical connections do not contact the rear surface; otherwise,
connections may be damaged.
• Do not trap the mains cable and do not route it over hot surfaces. The cable
insulation may melt and cause a fire as a result of a short circuit.
• Make sure that the product function knobs are switched off after every
use.
• When hot and cold air meet, condensation can form. The outer door is air
cooled and the inner glass will become hot during cooking, therefore some
condensation might form. This is perfectly normal. All condensation will
disappear as the oven reaches cooking temperature.
• Product must be installed by a qualified person in accordance with the
regulations in force. Otherwise, the guarantee may become void.
• Do not switch the oven off at the mains isolation switch immediately
after cooking. Cooling fan continues to run for up to 20-30 minutes
(approx) even after the oven control is turned off.
WARNING FIRE RISK: Do not place aluminium foil, baking trays or
cook on the base of this oven, doing so will cause permanent
damage to your appliance and cabinetry with the potential risk of
fire.
• Do not use harsh abrasive cleaners or sharp metal scrapers to clean the
oven door glass since they can scratch the surface, which may result in
shattering of the glass.
• Do not use a steam cleaner for cleaning operations.
• WARNING: Avoid possibility of electric shock - ensure the appliance is
switched off before replacing the lamp.
• The means for disconnection must be incorporated in the fixed wiring in
accordance with the wiring rules.
• The instructions state the type of cord to be used, taking into account the
temperature of the rear surface of the appliance.
User manual LAM3207
Exclusive to Howdens Joinery.co Page _ 5
