Version: 01
Recommended mounting instructions:
•Always mount on an interior wall, e.g., hallway
•Place the sensor 160-180cm above floor
•Mount the device so the hole at the front is down
•Avoid heating/cooling sources (solar radiation, lamps, pipes,
extensive airflow, etc.)
•Mount with either double-sided tape or screws
•If screws are used, make sure following requirements are fulfilled:
•Screw head angle must be at least 90°
•Screw head diameter (marked dk) approximately 5mm
•Screw head thickness (marked k) approximately 1.4mm
Step 1:
Start the device (it cannot be turned off once started).
1. Place a permanent magnet at the green arrow
2. A red LED will turn on - Keep holding the magnet
3. When the LED turns off - Remove the magnet
4. The LED shall flash for 10 seconds to indicate successful
startup
If the device is going to be mounted on a wall with double-
sided tape, simply stick the tape to the back of the device
and mount it to a wall using the recommended instructions.
The installation is now complete!
If screws are required, continue to the next step.
Step 2a:
Unhook one of the plastic hooks (top or
bottom) by pressing down with a small
object, for example, a screwdriver.
Step 2b:
Separate the back piece from the front.
Step 3:
Mount the back piece to a wall with the plastic pin at the
bottom using the recommended instructions. Two screws
are needed and shall be placed in the two holes marked by
red.
Attach the front piece to the mounted back piece- make sure
the hole on the front piece aligns with the plastic pin on the
back piece.
The installation is now complete!
