Using a bubble level, draw a line equal to the width of the cabinet. This indicates the top of the cabinet.
Once your stud has been loacted, using a bubble level, draw a line equal to the width of the cabinet.
This indicates the top of the cabinet.
Mark each of the drill holes to the left and right of the center at 204mm for the standard LYTE 10 WD wall door,
250mm for the LYTE 10 WD SP version and 291mm for the LYTE 10 WD U version.
Mark each of the drill holes to the left and right of the center at 204mm for the standard LYTE 10 WD wall door,
250mm for the LYTE 10 WD SP version and 291mm for the LYTE 10 WD U version.
Using the Allen key provided, unscrew the socket headed screw on the side of the AC panel
Pull the AC panel towards you and it will pivot and detach from the location studs on the
left hand side of the AC compartment.
1. Locate the AC panel on the location studs on the left hand side of the AC compartment
2. Rotate the AC panel into position such that the side screw slot is over the nut insert in
the central panel.
3. Using the Allen key provided, screw the socket head screw into the insert through the AC
panel slot to secure in position.
AC Panel (SD and WD units only)
