
67
Securing to a Desk (Optional)
It is possible to secure your ClassBuddyTM Desk down to the desk. To do so
you will require 4 x M4 bolts (not included).
The drilling pattern is 392mm x 338mm but please allow at least 40mm
from the rear of the desk.
Remove the feet fixing screws from the ClassBuddyTM Desk and secure
through the desk into the holes from the feet fixings. Retain the feet in
order to maintain a ventilation gap.
Complete
Your new ClassBuddyTM Desk should now be successfully installed and
ready to use. Please refer to the User Manual that is supplied with your
ClassBuddyTM Desk for further information. Please read the Health and
Safety guidance in the User Manual.
If you have any problems please do not hesitate to contact our support
team:
Replacement Keys
lapsafe.com/support/keys
Support Enquiries
lapsafe.com/support/enquiry
0800 130 3456
Step 5: Secure Rear Panel
Reconnect the earth cable you previously disconnected and refit all 10
screws back into place.