Larson Electronics EXP-LED-HL-MX2 User manual

!
!
!
EXP-LED-HL-MX2!
!
WARNINGS!
!
• To#prevent#ignition#of#a#hazardous#atmosphere,#batteries#must#only#be#changed#in#an#
area$known%to%be%non-hazardous.*!
• Use$only$energizer$E92$or$EN92$batteries.$!
• To#reduce#risk#of#explosion,#do#not#mix#old#batteries#with#used#batteries,#or#mix#
batteries(from(different(manufacturers.(!
• Substitution)of)components)may)impair)intrinsic)safety.)!
For$personal$safety,$always$confirm$the$rating$of$any$known$hazardous$or$potentially$
hazardous)location)where)the)flashlight)is)planned)to)be)used.)!
OPERATION)!
The$EXP-LED-HL-MX2!HAS$TWO$BUTTONS$THAT$CONTROL$LIGHT$OUTPUT:!
• Spotlight)Operation!
First#Press#–!Spotlight)Full)Power!High-Brightness!
Second#Press#–!Spotlight)Half-Power!Low-Brightness!
Third&Press&–!OFF#!
• Floodlight)Operation!
First&Press&–!Floodlight)Full#Power!High-Brightness!
Second"Press"–!Floodlight)Half-Power!Low-Brightness!
Third&Press&–!OFF!
!
Tilt%Adjustment%!
The$headlamp$light$pivots$on$a$ratchet.$Adjust$the$tilt$angel$of$the$light$to$illuminate'the'
desired&vision&area.!
!
HEADBANDS(!
The$headlamp$includes)two)types)of)headbands:!
!
1.#Elastic(Non-Slip%Headband!–!Use$this$headband$for$mounting$the$headlamp$directly$to$your$
head.&The&non-slip%feature%will%keep%the%light#positioned#on#the#head#even#with#vigorous#
movement.!
!
2.#Rubber&Hardhat&Strap!–!Use$the$rubber$strap$on$any$hardhat.$The$tacky$nature$of$the$strap$

!
!
will$keep$the$headlamp$attached$even$if$the$hat$is$dropped.$!
!
CHANGING'THE'BATTERIES'!
CAUTION:!To#reduce#the#risk"of"ignition"of"a"flammable"or"explosive"atmosphere,"batteries"
must%be%changed%only%in%a%location%known%to%be%non-hazardous.*!
1. Unscrew(the(battery(compartment(door(on(the(back(of(the(headlamp.(!
2. Install'3'AAA'batteries!(All$3$batteries$must$be$of$the$same$model)."Observe"the"correct"
polarity)of)the)batteries'per'the'outline'inside'the'battery'compartment.'Use'only'
approved(batteries:(E92(or(EN92(!
3. Close&the&battery&door&and&fasten&the&battery&compartment&door&screw.&CAUTION:)Do)
NOT$overtighten.$Doing$so$may$damage$the$threads$and$impact$the$light’s"Intrinsic"
Safety.!
4. The$headlamp$is$now$ready$for$use.$!
!