LARSON Golight User manual

GOLIGHT REMOTE OPERATION
A. The power button power’s the light on your Golight on/off. The Golight will continue to pan and
tilt with power supplied regardless of this setting.
B. The up, down, left and right arrows on the wireless remote control will move the Golight in the
corresponding direction. The Golight will rotate as long as power is supplied.
C. The tortoise/hare button sets the pan/tilt speed. Press it once for slower precise movement;
press it again for quick movement.
BATTERY INSTALLATION AND REMOVAL FOR TRANSMITTER
•Remove battery cover: For wireless hand-held transmitter, remove Phillips head screw
to remove cover. For wireless dash mount remote, simply remove the exterior rubber
cover.
•With battery compartment now exposed, gently remove old batteries by grabbing the
positive end and lifting up. Insert 2 X GP 23A 12V batteries according to the correct
polarity.

PROGRAMMABLE REMOTE INSTRUCTIONS
The Golight is controlled with a programmable remote with 2187 different channels. This feature
allows you the freedom to change the channel selection, and the receiver re-learns the new selection.
This light has been pre-programmed at the factory and is not necessary to re-program the transmitter,
unless you experience outside interference.
NOTICE
•The remote control is a transmitter. The light contains a receiver.
•The light is always “hot”. The light is constantly listening for a transmitter as long as it is
connected to power.
•Thus it is critical that you disconnect the power from the light you do not wish to
reprogram.
•All lights within 200 feet of a controller (transmitter) must be disconnected from their power
before completing this procedure.
1. Golight controllers have a series of dip switches on the back of the controller. The dip switches
are accessed by removing the battery cover. By default, all dip switches are set to the zero
position. Moving any one dip switch changes the channel for that transmitter (controller). Once
you have changed a dip switch, proceed to step 2.
2. Disconnect the power to the light you wish to control with the transmitter with the new
dip switch setting. For cigarette plug models, this means pulling the cigarette plug out of the
socket. For hard wired models, you may need to physically separate the crimped connection. On
vehicle installations, you might need to pull the fuse for that connection.
3. Press and hold down the ON/OFF button on the transmitter (controller).
4. Continue to hold down the ON/OFF button on the transmitter (controller) while
reconnecting the power to the light. Wait 5-8 seconds. The light bulb should turn on.
5. Now, that remote controller will communicate with the light only.
NOTE: When you install multiple Golights on one vehicle, vessel or other single power
source, connect each Golight to a separate fuse.