LATICRETE STONETECH User manual

STONETECH®Oil Stain Remover
DS 214.0-0516
Data Sheets are subject to change without notice. For latest revision, visit www.laticrete.com DS-214.0-0516
1. PRODUCT NAME
STONETECH® Oil Stain Remover
2. MANUFACTURER
LATICRETE International, Inc.
1 LATICRETE Park North
Bethany, CT 06524-3423 USA
Telephone: [phone]
Toll Free: +1.888.786.6343
Fax: [phone]
Website: www.laticrete.com
3. PRODUCT DESCRIPTION
STONETECH Oil Stain Remover is designed to remove oil-based
stains without discoloring the surface.
Uses (Interior and Exterior)
Countertops
Floors
Advantages
Pulls out deep-set oil stains
Leaves no permanent residue
Easy to use
Will not discolor stone
Recommended Surfaces
Natural stone, masonry and cementitious grout such as:
 Marble
 Granite
 Limestone
 Travertine
 Slate
 Sandstone
 Concrete
 Quartzite
Item Numbers and Packaging
D12446896 –3oz (88.7mL) Can, 6 units per Case, 300 units per Pallet
D12446904–1 Pint/16oz (473mL), 6 units per Case, 300 units per
Pallet
Products Available for Sale in Canada Only:
D12752546- 3oz (88.7mL) Can, 6 units per Case, 300 units per
Pallet
Approximate Coverage
½-1 ft2(0.05 –0.09 m2) of surface at ¼” (6mm) thickness per
pint (473 mL).
15-30 in2 (97-194 cm2) of surface at ¼” (6mm) thickness per
3oz. can (88.7 mL).
Shelf Life
Factory sealed containers of this product are guaranteed to be of first
quality for two (2) years if stored at temperatures >50°F (10°C) and
<90°F (32°C).
VOC Content
Not Regulated
Cautions
Consult SDS for more safety information.
Inhalation: Remove victim to fresh air and keep at rest in a
position comfortable for breathing. Get medical attention if any
discomfort continues.
Skin contact: Take off immediately all contaminated clothing.
Wash contaminated clothing before reuse. If skin rash or an
allergic skin reaction develops, get medical attention.
Eye contact: Immediately flush eyes with plenty of water for at
least 15 minutes. Remove contact lenses, if present and easy to
do. Continue rinsing. Get medical attention.
Ingestion: Rinse mouth. Do not induce vomiting. If vomiting
occurs, keep head low so that stomach content doesn't get into
the lungs. Get medical attention if any discomfort continues.
Storage and Handling Instructions
COMBUSTIBLE. HARMFUL IF SWALLOWED. Do not ingest. Avoid
prolonged exposure to vapors. Use only in a well-ventilated area. MAY
CAUSE EYE, SKIN AND RESPIRATORY IRRITATION. Avoid contact
with eyes and skin. Wear solvent resistant gloves such as nitrile
gloves. KEEP OUT OF THE REACH OF CHILDREN. Do not store
above 100 °F (38 °C). Do not mix with other chemicals. Do not release
to natural waterways.

Data Sheets are subject to change without notice. For latest revision, visit www.laticrete.com. DS-214.0-0516
4. TECHNICAL DATA
Physical Properties
Form
Paste
Color
Grey
Odor
Lemon
5. INSTALLATION
Surface Preparation
Read entire label before using. Use only as directed. Always test in a
small inconspicuous area to determine that the desired results will be
achieved. Make sure surface is clean, dry, and free of waxes and
coatings. Ensure that area is well-ventilated and keep children and
pets away from the area during application and until surface is clean
and dry.
Directions
1. Using a plastic or wood spatula, stir thoroughly to mix the paste.
2. Apply a ¼” (6mm) thick layer of paste to the stain. Ensure that the
paste extends at least 1–2” (25-50mm) beyond the edge of the stain.
3. Do not cover.
4. Allow 48–72 hours for paste to completely dry.
5. Using a plastic spatula, remove dried product and discard.
6. Allow solvent to completely dry from the stone.
7. If stain is not completely gone after drying, repeat process.
8. Clean up residue and tools with mineral spirits.
9. Once the surface is dry, reseal the cleaned area with a
STONETECH Sealer (e.g. STONETECH®BulletProof®).
6. AVAILABILITY AND COST
Availability
LATICRETE®, STONETECH and LATAPOXY® materials are available
worldwide.
For Distributor Information, Call:
Toll Free: +1.888.786.6343
Telephone: [phone]
For on-line distributor information, visit LATICRETE at
www.stonetech.com or www.laticrete.com
Cost
Contact a LATICRETE Distributor in your area.
7. WARRANTY
See 10. FILING SYSTEM:
DS 230.13:LATICRETE Product Warranty
8. MAINTENANCE
Highly alkaline, acidic, ammoniated, and/or abrasive cleaners are not
necessary for daily maintenance and may also degrade the sealer,
adversely affecting stain resistance. Tile and stone routine cleaning
with a neutral pH cleaner such as STONETECH Stone & Tile
Cleaner is recommended. For tough or difficult to remove soil use
STONETECH KlenzAll™Cleaner, a nylon scrubbing pad or a long
handled stiff bristle brush. Please note: Prior to using any cleaning
material on a tile, stone, etc. installation, test a discrete area or scrap
piece of tile to insure desired results. For additional information,
please refer to the TDS 262 Stone and Tile Care Guide.
9. TECHNICAL SERVICES
Technical Assistance
Information is available by calling the LATICRETE Technical Service
Hotline:
Toll Free: +1.888.786.6343 , ext. 2
Telephone: [phone], ext. 235
Fax: [phone]
Technical and Safety Literature
To acquire technical and safety literature, please visit our website at
www.laticrete.com or www.stonetech.com.
10. FILING SYSTEM
Additional product information is available on our website at
www.stonetech.com. The following is a list of related documents:
DS 230.13: LATICRETE Product Warranty
DS 211.0: STONETECH Stone & Tile Cleaner
DS 215.0: STONETECH KlenzAll Cleaner
TDS 262: Stone and Tile Care Guide
DS 282.0: STONETECH Bulletproof