How to install Laura Ashley Peel, Stick & Seal glass splashbacks
What you need
Before you start
Easy to apply
Tape Measure
Check that your splashback fits the space.
This will depend on size of splashback
ordered and your preferred orientation.
Make sure all corners are well protected
from any hard surfaces. Carefully peel off
the protective film back. Take care not to
remove the self-adhesive backing.
Place the bottom edge of the splashback
to the rear of the hob, cooker, range
or sink. Push it to the wall and apply firm
even pressure with a cloth.
Use the Clear Silicone Sealant to seal
around all four sides of the splashback.
Take care to ensure that the sealant
is no more than 2.5mm in thickness.
Check the surface is
perfectly flat, non-porous,
dry and dust free.
Clear Silicone Sealant
- Low Modulus Type
Sealant Gun Clean Cloth Splashback
1
PEEL off backing
1STICK on the wall
2SEAL the edges
3
3
Your splashback must
be at least 110mm
away from the
nearest heat source.
2110mm
Splashback
to go here
Please Note:
• Our splashbacks are made
from high quality toughened
glass so cannot be cut.
• Once in place our self-
adhesive splashbacks
cannot be repositioned.
