LDA Audio Tech NEO Series User manual

Support Handbook
Safe battery installation
Reference: NEO Series

Safe battery installation
Support Handbook - NEO Series
1 INTRODUCTION
To perform a safe connection between the batteries and the battery charger, please read
this handbook carefully.
Do always use EN-54 certified chargers and batteries, as the ones pro ided by LDA with our
PA/VA systems.
For further information about the connection between the battery charger and the PA/VA
system, please refer to the “Emergency power supply in NEO Series” handbook you can find
at support.lda-audiotech.com.
2 WIRIN INSTRUCTIONS
1. Make sure the battery charger is disconnected before starting the proccess.
2. Connect the negati e pole of the first battery to the positi e pole of the second battery.
3. Connect the negati e pole of the second battery to the negati e output in the battery
charger.
4. Connect the positi e pole of the first battery to the positi e output in the battery charger.
5. Power the battery charger ON.
6. Make sure the installation is wired as shown on the diagram below.
WARNING: Do never connect the positive and negative poles of the same battery.

Safe battery installation
Support Handbook - NEO Series
For more information, please, contact with our Support Department at:
[email protected]