LDA Audio Tech NEO Series User manual

MANAGE MICROPHONES PRIORITY
Support Handbook
LDA Audio Tech - Severo Ochoa Nº 31- 29590 MÁLAGA, ESPAÑA. 1
Tl : [phone]. www.lda-audiotech.com
A. Connecting the mixer of microphones to NEO
Connect the mixer output in one audio input of NEO using the balance audio (positive,
negative and ground) and using t o resistances of 10K ohm in positive and negative
output from mixer (refer to balance connection manual).
We ill use the input 1 as per the connection diagram (refer to SLD diagram).
NOTE: Remember that you have a MPS-8Z connected in the MIC REMOTE socket, so the
input 5 will be disabled.
B. Checking the connection
Once you have connected the signal, check the level of the sources (microphones) routing
the input selected to all output (refer to “NEO User's Manual”) and test the green led of
zone (refer to INDICATORS in “NEO User's Manual”).
C. Link and connect the NEO device
Follo s the steps described in the “NEO Configurator User’s Manual PART 1” document to
connect the NEO-8060 and import the configuration in a ne project (refer to 3. PROJECT
SETUP at page 15).
Once you have connected the system ith NEO Config, e are going to set the event as
per the requirements: whenever any microphone talk , the y tem will route thi input
to a particular zone and when the microphone i off, the zone will get back to previou
routed mu ic in that zone.

MANAGE MICROPHONES PRIORITY
Support Handbook
LDA Audio Tech - Severo Ochoa Nº 31- 29590 MÁLAGA, ESPAÑA. 2
Tl : [phone]. www.lda-audiotech.com
D. Creating the event in NEO Config
Follo the steps indicates in the “NEO Configurator User’s Manual PART 1” document to:
-Create a trigger ith these features:
i. Type: “Input Level”
ii. Argument1: “1:Source #1”
iii. Argument2: “-15 dB”
-Create a condition ith this trigger.
-Create an action (type “Route”) to route the “01:Source #1” to “All zones” or
desired zones.
- Create an event ith the follo ing condicionts and actions:
Please for any other information contact with LDA Support Department
[email protected]