Leaf Bass 2 User manual

User Manual - Leaf Bass 2
OVERVIEW
TURNING ON/OFF
Please charge your Leaf Bass 2 for 2.5 hours before turning on for enhanced battery life.
Turning ON: Press and hold the multifunction button until you hear “Power on” and you see the
blue light flashing.
Turning OFF: Press and hold the multifunction button until you hear turn off sound.
BLUETOOTH PAIRING MODE

1. Keep your Leaf Bass 2 within 1 meter when pairing.
2. Make Leaf Bass 2 enters pairing mode as shown:
—Ensure Leaf Bass 2 is off. Press and hold the Power Button for approximately 2 seconds until
Blue LED flashes rapidly.
1. In the Bluetooth settings of your mobile phone, scan/search for available bluetooth
devices. Select “Leaf Bass 2” from the list of devices shown.
2. If prompted, enter password or PIN No: “0000”
3. If prompted by your mobile phone to connect, select “Yes” (This will vary among mobile
phone models).
4. After connecting successfully, blue LED of headphones will stop flashing.
CHARGING
Leaf Bass 2 comes with a built-in rechargeable battery, prior to using it, It is recommended to
charge the battery fully for the first time.
1. Plug in the micro USB in the charging port.
—Red Light ON : Charging
—Red Light OFF : Fully Charged
1. It will take about 2.5 hours to fully charge.
ATTENTION : Do not charge products with Turbo charger, chargers with current output > 1.2 A
CONTROLS
Leaf Bass 2 comes with loaded functionalities which you can use to control music, calls and
much more.

USING AUX
NOTE : If your Leaf Bass 2 is fully discharged you can still use it to listen to music by plugging
in Aux.
Insert one end of Aux in Leaf Bass 2’s aux port and other end in your mobile and start listening
to music worry free.