Operating your Coffee Grinder
• Clean the appliance before use. (See Care and
Storage)
• Place the coffee grinder on a stable surface,
fully unwind the electrical cord and plug into
the power point.
• Remove the lid (twist anti-clockwise) and
measure the desired quantity (maximum 50g)
of coffee beans into the lid of the grinder. The
lid when full is 50g. If grinding hard herbs or
spices we recommend not filling to maximum
level, grind these in smaller batches to prevent
overloading the grinder.
• Tip the beans into the base unit of the grinder
and refit the lid.
• Press lightly down on the lid and twist
clockwise to lock the lid into position.
• Press and hold down the button to start
grinding the coffee beans.
• When the coffee beans have reached the
desired grind (usually after approximately 30
seconds) release the pressure on the button.
• Allow the blades to stop spinning before
removing the lid to check the consistency of
the grind.
• If further grinding is required, replace the lid
and repeat the steps above. If the grinder does
not operate after replacing the lid, check that
the rim is free of coffee grounds.
• Remove the ground coffee and use, never store
ground coffee in the grinder.
• Clean and allow the base unit to cool before
storing.
NOTE: Do not operate for more than 60 seconds.
If desired grind is not achieved after 60 seconds
of continuous use allow the grinder to cool for 60
seconds before restarting.
Care and Storage
• Switch off the grinder and unplug.
• Remove the lid and wash in warm water.
Rinse and wipe dry, ensure no water is caught
inside the lid, if there is simply shake the lid to
remove. The grinder is not dishwasher safe.
• Taking care not to touch the blades with your
hands, remove any residual coffee grounds
from the base unit and lid rims using a brush.
• Allow to dry thoroughly before storing.
• Wipe the outside of the appliance with a damp
cloth.
• Do not use abrasive cleaning agents as these
may scratch the surface.
• Never immerse base unit, electrical cord or
plug in water.
• Store the cord by winding into the cord storage
compartment in the base.
Albi Guarantee
Our goods come with guarantees that cannot be
excluded under the Australian Consumer Law.
You are entitled to a replacement or refund for
a major failure and for compensation for any
other reasonably foreseeable loss or damage.
You are also entitled to have the goods repaired
or replaced if the goods fail to be of acceptable
quality and the failure does not amount to a
major failure.
The benefits of this warranty are in addition to
any rights and remedies imposed by Australian
State and Federal legislation that cannot be
excluded. Nothing in this warranty excludes,
restricts or modifies any State or Federal
legislation applicable to the supply of goods
which cannot be so excluded, restricted or
modified.
Guarantee
We warrant that, subject to the exclusions and
limitations below, the Product will be free from
defects in materials and workmanship under
normal domestic household use. The 12-month
warranty period commences on the date of sale
by the original retailer to the original purchaser.
The warranty applies only while the Product is
owned by the original purchaser.
Use of the Product in a commercial capacity
will void this warranty. If a defect appears in
the Product before the end of the warranty
period and we find the Product to be defective in
materials or workmanship, we will, in our sole
discretion either:
(a) repair the Product using identical or similar
components; or
(b) replace the Product with a product
comparable in quality and value.
We reserve the right to change or discontinue
our product ranges at any time without notice
and without liability.
