• Place kettle onto the power base and plug
in the power (the indicator will turn on for a
second and turn off).
• Press the switch button once and the kettle
will enter a boiling state (the indicator will
light up). When the water temperature
reaches 100°C, the power is switched off
automatically and the indicator will turn off.
Care:
• This appliance cannot be used next to high
temperature objects. Please do not dry in
an anhydrous state, otherwise damage to
the heat plate and heating pipes are likely.
• If water in the kettle is too little or
accidentally dries during use, the power
cord should be unplugged. Allow it to cool
down and then add cold water.
• When using, the kettle should be placed
on a flat surface and not easily accessible
to children.
• Do not immerse this appliance in water or
other liquids.
• When water is boiling, do not touch the
steam escaping from the nozzle and do not
rush to open the lid as this avoids being
scalded by steam.
• When the kettle is not completely cooled
down but needs to be refilled, be careful
when opening the lid.
• Please make sure the lid is fully locked before
turning on the kettle. Do not open the lid
when the kettle is on. The automatic Switch
Off may not work if the lid is not fully closed.
• Do not open the lid when pouring boiling
water.
• This kettle is only intended for boiling
water, not coffee, tea, alcohol or chemicals.
• Do not touch the high temperature surface
of this kettle when boiling to avoid scalding.
• After boiling, do not press the switch to
avoid damage to the thermostat.
Cleaning:
To keep this kettle in good working condition, it
must be cleaned frequently. When cleaning the
kettle, make sure to disconnect the power cord
and wipe the kettle shell with a damp cloth. Do
not immerse the kettle in water during cleaning.
Our 12-month Guarantee
Our goods come with guarantees that cannot be
excluded under the Australian Consumer Law.
You are entitled to a replacement or refund for
a major failure and compensation for any other
reasonably foreseeable loss or damage. You are
also entitled to have the goods repaired if the
goods fail to be of acceptable quality and the
failure does not amount to a major failure.
We stand by this product. Therefore we offer a
12-month guarantee on the heating element.
The benefits of this guarantee are in addition to
any rights and remedies imposed by Australian
Consumer Law. Our guarantee excludes normal
wear and tear and instances where care and use
instructions have not been followed.
What IsAlbi will do: During this guarantee
period, IsAlbi will repair, replace or refund any
defective product. If identical product is not
available for replacement, a similar product
may be offered. IsAlbi asks you to cover the cost
of postage/transit if the product needs to be
sent back to us for inspection. If IsAlbi deems
the product is defective, we will reimburse
your postage/transit expenses. IsAlbi will
be responsible for the postage/transit of the
repaired/replacement product back to you.
What to do: If a fault/defect is identified, cease
using the product immediately.
To make a claim on this guarantee, take the
product, proof of purchase and full details of
the alleged defect to the retailer from whom the
product was purchased. If you cannot access
the retailer or are unsatisfied with the solution
offered by the retailer, contact IsAlbi via the
details below.
IsAlbi
87 Chifley Drive, Preston, Victoria 3072
P: +61 (03) 9474 1300
www.isalbi.com.au
