Lectron Portable Level 1 Charger 16A User manual

Portable Level 1 Charger 16A
User Manual

In the Box
1 x portable Level 1 charger 16A
Warning
• It is recommended that electrical outlets for your mobile connector be installed
by a licensed and qualified electrician. To avoid serious injury or death,
installation must comply with the provisions of the National Electric Code (NEC)
and all local codes. In cases of any conflict between the local codes and the
NEC, local codes shall take precedence.
• This product must be grounded. If it should malfunction or break down,
grounding provides a path of least resistance for electric current to help reduce
the risk of electric shock. This product includes a cord that is equipped with a
grounding conductor and a grounding plug. The plug must be inserted into an
appropriate outlet that is properly installed and grounded in accordance with all
local codes and ordinances.
• DO NOT DROP the handle or the mobile connector.
• If the plug separates from the mobile connector or handle, DO NOT ATTEMPT
TO REPAIR THE CABLE YOURSELF.
Page 1

Charger Components
Safety Information
When using your charger, always follow basic precautions including the following:
• Read warnings on the back of the mobile connector and all instructions in
this manual before operating.
• Never use the mobile connector with a power strip.
• Never use the mobile connector with an AC adapter/transformer.
• Shock hazard – make sure the plug is fully inserted into the wall outlet
so that there are no exposed blade surfaces.
• Children should be supervised when in the vicinity of the charger while it is
plugged in.
• To reduce the risk of fire, connect only to a circuit providing 20A maximum
branch circuit overcurrent protection.
• Power
• Connected
• Charging
• Fault
Release button
Handle
POWER
CONNECTED
CHARGING
FAULT
NEMA
5-15 plug
Page 2

Charging Your Vehicle
Note:
Ensure that the car is parked and the engine is turned OFF.
1. Insert the charger into an appropriate wall outlet.
2. The power light will turn solid orange and the connected light will turn solid
green, indicating that your charger is receiving power and is ready to be used.
POWER
CONNECTED
CHARGING
FA ULT
Page 3

3. Plug the handle into your vehicle's charging port so it clicks firmly into place.
4. Charging begins automatically. The charging light will blink blue continuously.
POWER
CONNECTED
CHARGING
FA ULT
Page 4

1
2
5. When your vehicle is fully charged, the charging light will stay solid blue.
You can also verify the charging status by checking your vehicle's dashboard.
6. When charging is complete, press the button on the handle and pull it out of
the charging port.
POWER
CONNECTED
CHARGING
FA ULT
Fully charged
+ 0 km 6/6 A 210 V
Page 5

Troubleshooting
Please refer to this guide if you have any problems while using this charger.
Charging light
does not illuminate.
Problem Possible Cause Solution
Vehicle will not charge.
Fault light remains
solid.
Fault light is
blinking rapidly.
No power to the charger. 1. Check the circuit breaker and other circuit loads.
2. Try another wall outlet.
3. Ensure that the charger module (and adapter if
operating in 120 VAC mode) is fully inserted into
the wall outlet.
Charger internal failure. Contact Lectron Customer Support at
[email protected] for assistance.
Handle is not inserted into
the vehicle.
1. Inspect the handle.
2. Remove the handle from the vehicle. Then reinsert
it into the vehicle's charging port, so it clicks firmly
in place.
Vehicle is not in a state to accept any
charge.
Verify that the vehicle charge timer is set to permit
charging. Refer to the vehicle owner’s manual for
charge timer instructions.
Communication error between the
charger and vehicle.
Utility fault.
Above the temperature limit.
Cases:
1. Temperature is too high. The
charger will restart charging when it
cools down.
2. House/socket wiring may be
faulty.
1. Inspect the charger module for overheating.
a. Carefully unplug the charger module from
the wall outlet and allow to cool.
b. If the condition persists, contact Lectron
Customer Support at [e-mail]
for assistance.
2. Disconnect the charger from the wall outlet.
3. Have a qualified electrician inspect the wall
outlet and adapter.
1. Disconnect the charger module from the wall
outlet, then reconnect it.
2. If the condition persists, have a qualified
electrician inspect the ground circuit of the
wall outlet.
Contact Lectron Customer Support at
[email protected] for assistance.
Page 6

Specifications
Line input power:
Voltage range:
Frequency:
Maximum current:
Cable length:
Plug:
Ev connector:
Dimensions:
Weight:
Operating temp:
110 - 120 V (NEMA 5-15)
110 - 240 V (NEMA 5-15)
60 Hz
16 A
18 ft cable (total reach: 21 ft)
NEMA 5-15 plug
SAE-J1772
9.5 x 3.5 x 2.4 in
4.6 lb
-22 °F to +122 °F
Get More Support
Scan the QR code to contact us or send us an email at [e-mail].
For more information, visit:
www.ev-lectron.com
Made in China