3. UNDOCKING LAPTOP FROM DS.GD8 SERIES DOCKING STATION
4. INSTALLING DS.GD8 SERIES DOCKING STATION
TO THE MOUNTING BRACKET
Press the UNDOCK button
to disconnect laptop from
dock. The green LED on the
right side will turn off once
it is safe to undock laptop.
After the mounting
bracket is installed, attach
the DS.GD8 Docking Station
and screw in the front
3 hex screws, making sure
not to completely tighten.
Press barrel lock button in
to disengage the mounting
clamps. (Make sure lock is
in the open position)
Screw in the 3 hex screws
located in the back of the
mounting bracket. Tighten
both screws until secure.
Lift laptop from the back
first, then from the front
mounting bracket.
Return to the 3 hex
screws in the front and
tighten completely.
If you undock your laptop before the right side green LED has turned off,
your laptop must be restarted in order for the operating system to be used
If the DS.GD8 Docking Station is not attached to the mounting
bracket as specified in Step 4, parts may crack or become damaged.
A.
A.
B.
B.
C.
C.
1.877.875.5524 www.LEDCO-CHARGEGUARD.com/GD8Dock
If laptop screen is closed or in the sleep mode prior to undocking, you
will need to open and start laptop before pressing the UNDOCK button.
For complete, detailed directions on correct installation and
Torque Requirements please refer to the Installation Instructions
included inside the DS.GD8 Docking Station Hardware Kit.
NOTE
NOTE
GD-0026-IS-A
Additional mounting screws and keys are included in the attached Hardware Kit
DS.GD8 Docking Station User Guide
Compatible with General Dynamics-Itronix GD8000 & GoBook XR-1 Laptops
