LEDEKSPERT KT.SR-2811PWM-V/M User manual

Wall mounted RGB/W controller
Parameter
Product Size
Part No. Operation Voltage DIMENSIONS
ø/h (mm)
OUTPUT
KT.SR-2811PWM-V/M 12-24VDC 86x86x29.1
4x5A
29.1
86.0
86.0
12-24VDC
Power Supply
Installation
KT.SR-2811PWM-V/M

Product introduction
Wiring diagram
1 zone
Output PWM signal, connect strip directly
Touch sensitive
Glass interface(White & Black)
Save color and mode function
G W
LN
110V-230VAC
Power Supply
12-24VDC
R B
INPUT
KT.SR-2811PWM
Operation
Play&pause button. There is only 1 build-in mode. When you touch this button, it will run.
Speed upSpeed down
Brightness
Button can save the color from mode or save color when you touch color wheel.
In "S" button, it saved "R/ G/ B" 3 colors in default. But with your operation, you can save another 3 colors
replace those R/G/B colors.
When you press this button, 1 build-in mode will run, if now you see a favorite mode, then you can press
"S" button for 5 seconds until connected lighting flashes. Then it saved successfully.
When you touch color wheel, if you touch a favorite color on it, then you want to save it, then you press
"S" button for 5 seconds until the connected lighting flashes. Then it saved successfully.
For Warm white, Natural white, Cool white changing.(Through the three RGB color mixing)
Touching wheels Switch off and on, long press means default setting
Short press means switch on and off for each channel. 1st Long press means brightness+, 2nd
Long press means brightness—.
At the corner of the panel there is a signal light, Blue means on, Red means off
1) The product shall be installed and serviced by a qualified person.
2) IP20.Please avoid the sun and rain. When installed outdoors, please ensure it is mounted in a water proof
enclosure.
3) Always be sure to mount this unit in an area with proper ventilation to avoid overheating.
4) Please check if the output voltage of any LED power supplies used comply with the working voltage of the
product.
5) Never connect any cables while power is on and always assure correct connections to avoid short circuits
before switching on.
6)
7) For update information please consult your supplier.
Please ensure that the cable is secured tightly in the connector
Safety & Warnings