LEDstuff LED-CONMINRGB User manual

INSTALLATION:
1. Connect the Red, Green, Blue and White (common
positive) wires to your RGB product.
2. Plug the wire connector into the LED controller,
ensuring the arrows line up (white wire on top) as
indicated below. We recommend heatshrinking this
connection.
3. Connect the RGB controller to a 5, 12 or 24V DC power
supply (no larger than 12A).
4. Remove the plastic barrier from the battery
compartment in the remote control to activate it.
5. Your RGB lighting is now ready to use!
• 22 dynamic modes
• 20 static colours
• Smooth transitions
• Speed adjustable
• Brightness adjustable
• Direct colour selection
• Demo mode
• Easy remote pairing
SPECIFICATIONS:
RGB RF CONTROLLER
LED-CONMINRGB
Dynamic Mode
22 modes
Static Colour
20 colours
PWM Grade 256 levels
Brightness Grade
5 levels
Speed Grade
10 levels
Output Colour Switchable
Yes, 6 options
Working Voltage
5-24V DC
Output Current
3x4A peak, 3x2A constant
Remote Frequency 433.92MHz
Remote Range
>15m
These arrows must line up

PAIRING/UNPAIRING REMOTES:
To pair the remote to the controller/strip, power on and
short press the COLOUR- and BRIGHT- buttons together
within 5 seconds. The lights will ash white to show the
pairing has been successful.
You can pair a remote to multiple controllers. There is no
unpairing function, but you can pair a remote with another
controller to undo the rst pairing.
FUNCTIONS:
1: TURN ON/STANDBY
Press this key to turn on the unit or switch to standby
mode. At power on, unit will restore to previous mode.
2/9: DYNAMIC MODE ADJUST
Switch to dynamic mode from static colour, or switch
between dynamic modes.
3/10: DYNAMIC SPEED ADJUST
Adjust dynamic playing speed. Press SPEED+ to increase
speed and press SPEED- to decrease. Unit will switch to
dynamic mode if pressed at static colour mode.
4/5: STATIC COLOUR ADJUST
Switch to static colour mode from dynamic mode, or switch
between static colours.
6: DIRECT COLOUR SELECT
Shortcut key to static colours. The direct colours are
included in COLOUR+ and COLOUR- operation.
7/8: BRIGHTNESS ADJUST
Adjust static colour brightness. Press BRIGHT+ to increase
brightness and press BRIGHT- to decrease. Unit will switch
to static colour mode if press this key at dynamic mode.
11: DEMO MODE
Press this key will switch to Demo mode. At demo mode, it
plays 17 dynamic modes in loop, each mode repeating 3
times.
1
2
3
4
5
11
10 9
8
7
6