Lee Valley Tools Kill-A-Watt P4400 Installation manual

Kill-A-Watt™Energy Meter
(99W69.37)
The following instructions were provided by the manufacturer.
P4400 Kill A Watt ™Operation Manual
Congratulations on your purchase of the Kill A Watt™Power Meter. Cared for properly,
this unit will provide you with years of service.
1. The LCD shows all meter readings: Volts, Current, Watts, Frequency, Power
Factor, and VA. The unit will start to accumulate KWH and powered duration time
(hour) after power is applied.
2. Press Volt Key for true RMS Voltage (Volts) display.
3. Press Amp Key for true RMS output current (Amps) display.
4. The Watt/VA Key is a toggle function key. Press the Watt/VA key once to display
Watt meter, then press key to display VA meter. The LCD will display Watts as the
active power, where VA is the apparent Power. (VA=Vrms Arms)
5. The HZ/PF is a toggle function key. Press the HZ/PF key once to display the
frequency (Hertz), then press key to display the Power Factor. HZ is the
Frequency of output Voltage, where PF is the Power Factor (PF=W/Vrms Arms) .
6. The KWH/Hour is a toggle function key. Press the KWH/Hour key once to show
the cumulative energy consumption since power was applied to the unit. Then
press key to display the cumulative time since power was applied to the unit.
7. Consumption will be displayed in Kilowatt-Hours (from 0.01 KWH to 9999 KWH).
Time will initially be displayed as Hours:Minutes (from 00:00) and switch to Hours
(to 9999). Counters will recyle to zero when they reach their maximum. To reset,
remove power from unit momentarily.
WARNING: Do not exceed maximum ratings as detailed on label.

©Copyright 1998 to 2009 by Lee Valley Tools Ltd. and Veritas® Tools Inc. All rights reserved.