Lefroy Brooks FLEETWOOD M2-5470 User manual

INSTALLATION INSTRUCTIONS
M2-5470
FLEETWOOD 20" SHOWER DOOR HANDLE WITH SINGLE AND DOUBLE MOUNTING KIT

2
2
Dimensions
Whilst every effort is made to ensure accuracy, design and dimensions are subject to
change without notice as part of the company’s product development process.
M2-5470
20"
(508mm)
1/8"
(3mm)
1 1/4"
(32mm)
Ø1 3/8"
(Ø35mm)
Ø1 1/16"
(Ø27.5mm)
Ø15/16"
(Ø24mm)
1/16"~1 1/8"
(1mm~28mm)
2 1/16"
(53mm)
Ø11/16"
(Ø18mm)
1/8"
(3mm)
1 3/16
(30mm)
1 3/8"
(Ø35mm)
1 15/16"
(Ø50mm)

3
What you need to know
Prior to beginning installation. turn off the cold and
hot water lines and open the old faucet to release
built-up pressure.
Overtightening nuts may cause damage.
Wrap all threaded connections with pipe tape
available at your local plumbing supply store.
Always wrap in a clockwise direction. The fittings
should be installed by a state-licenced plumber.
Adjustable Wrench
Groove Joint Pliers
Hacksaw
Phillips Screwdriver
Pipe Tape
Spatula
Spirit Level
Your new bathroom faucet is designed for years
of trouble-free performance.
Keep it looking new by cleaning it periodically with
a soft cloth. Avoid abrasive cleaners, wire wool and
harsh chemicals as these will dull the finish and
void your warranty.
If you are soldering during faucet installation,
remove cartridges, seats, gaskets and washers
prior to applying flame, otherwise you will void
the warranty.
Cover drain openings to avoid losing small parts.
When cutting or soldering pipe, use safety glasses
to protect your eyes.
Correct installation may vary depending on previous faucet installation. All necessary supplies required for
faucet installation are not included, but may be found where plumbing supplies are sold. It is suggested that
IAPMO and/or CSA approved plumbing supplies are used during installation.
Tools: Maintenance
Safety Tips
Things You May Need
Important Points

4
Steps 1-3
Installation Procedure
Lefroy Brooks always recommends that plumbing products be installed by a licensed professional.
Shut off main water supply before installation.
20"
(508±1mm)
Ø1/2"
(Ø12~13mm)
1/16"~1 1/8"
(1~28mm)
3Insert the stud bolts through the holes.
Attach the brackets and rubber washer on
to the stud bolts and fix them with the nuts.
1Before installation, make sure the dimen-
sions for the shower door are as indicated
above. Please note: this product can also be
orientated vertically.
2Screw the stud bolt into the decorative nut
with the rubber washer attached.
3
1 2

5
Steps 4-5
Installation Procedure
Lefroy Brooks always recommends that plumbing products be installed by a licensed professional.
Shut off main water supply before installation.
4Attach the door handle on to the brackets.
In case the holes on the brackets are not in
line with the handle's posts, please return
to step 3 - loosen the nuts a little to adjust
to the proper distance between the two
brackets, then fix the nuts again.
5Fix the handle tightly with set screws.
4 5

6
Steps 6-7
Installation Procedure
Lefroy Brooks always recommends that plumbing products be installed by a licensed professional.
Shut off main water supply before installation.
6In case you are buying two sets of this
product and want to convert them into a
double shower door handle, please take the
following steps. Firstly, screw the stud bolts
into the nuts. Please note: the slots on the
bolt and nut have to be on the same side.
7Insert the stud bolts (please take note on the
direction as the figure shows) through the
brackets, rubber washers and holes in turn.
Stop the stud bolt rotating with a screwdriver
bracing it. meanwhile, attach the brackets on
the other side to the stud bolts and fix them
with the nuts.
6 7
K
K
4:1

7
1 Rail (258136-X)
2 Post (244044)
3 Set screw (065086)
4 Bracket (245029)
5 Set screw (292001)
6 Nut (009348)
7 Stud bolt (017251)
8 Rubber washer (058171)
9 Decorative nut (243048)
10 Decorative nut (243218)
11 Wrench (031272)
12 Allen key (031003)
13 Pull-knob (259138)
Exploded View
Parts List
M2-5470
1
2
3
4
5
6
7
8
9
11
12
10
13

For additional assistance or service call
718-302-5292
9am to 5pm EST Monday to Friday
LEFROY BROOKS INC, 1828 TROUTMAN STREET, RIDGEWOOD, NY, 11385
TELEPHONE: [phone]. FAX: [phone]
The use of trademarks, product design and artwork is subject to licence or agreement with LBIP Ltd. The design
registrations, trademark registrations and copyrights are protected by law and the use or reproduction outside the terms of an agreement is prohibited.
The right to modify designs and dimensions is reserved. Christo Lefroy Brooks is a member of ACID (Anti Copying in Design).
© LBIP LTD 2012
www.lefroybrooks.com