LEGRAND CM2002 User manual

Part Number:
CM2002 - One-Camera IP Video Server
CM2002 IP Video Server Features
Video In
Audio
DO G DI G Out In
Ethernet
PoE
DC 12V
In G Out G D+ D-
1 2 3 4
Fig. 1 Front View Fig. 2 Back View
5 6
Fig. 3 Side View
No. Label Operation
1DC 12V 12 VDC in/out connection ports
D+/D- RS485 connection port
2 Ethernet PoE RJ-45 connection port
3DI/DO DI/DO connection port
Audio Audio in/out connection ports
4 Video In BNC video-in signal connection port
5 Micro SD card slot
6 Default Factory default reset button
Installation Instructions
One-Camera IP Video Server
1507280
Ethernet
PoE
DC 12V
In G Out G D+ D -
Ethernet
PoE
DC 12V
In G Out G D+ D -
Default

2
Introduction
The CM2002 One-Camera IP Video server converts an analog video source into an IP video stream. The Legrand Intuity app auto-discovers
the IP Video Server for easy integration of the SCI Video Door Unit with the app. Connect your compatible devices and move another step
closer to the total home control experience.
Standard Setup (Fig. 4)
Video In
Audio
DO G DI G Out In
Power Supply
SCI Video
Door Unit
BNC to
RCA Cable
SCI Room Unit
SCI Intercom
Module
Fig. 4 Standard Setup
Installation
Setting Up Monitors (Fig. 5)
STEP 1: Press the right mouse button while hovering over the computer (PC) desktop.
STEP 2: Select Screen Resolution from the menu.
STEP 3: Select Advanced Settings.
STEP 4: Select the Monitor tab and change the Colors drop-down menu to read True Color (32bit).
Fig. 5 Monitor Settings

3
Connecting to a Power Over Ethernet (PoE) Device (Fig. 6)
STEP 1: Connect the CM2002 to a power source.
STEP 2: Connect a PC or a PoE switch/network video recorder (NVR) to the CM2002 Ethernet connection port using an Ethernet cable.
STEP 3: Configure the network settings according to the network environment being used.
STEP 4: Connect an analog camera to the CM2002 video-in connection port using a BNC cable.
Note: This step assumes the camera is already set up and powered. The CM2002 does not provide power to any external device.
Default
Video In
Audio
DO G DI G Out In
Ethernet
PoE
DC 12V
In G Out G D+ D- Ethernet
PoE Device
BNC end of included
RCA/BNC Cable Assembly
Fig. 6 PoE Device Connections
Installing the Micro-SD Card (Fig. 7)
STEP 1: Locate the micro-SD label on the CM2002.
STEP 2: Insert the micro-SD card into the slot located immediately below the label.
Ethernet
PoE
DC 12V
In G Out G D+ D-
Ethernet
PoE
DC 12V
In G Out G D+ D-
Default
GB
Fig. 7 Micro-SD Card Slot

4
Assigning the Device IP Addresses
STEP 1: Locate the mini-CD in the package contents.
STEP 2: Insert the mini-CD into a PC.
STEP 3: Open the Applications folder on the mini-CD and choose IP Scanner.
Note: The IP Scanner software supports multiple languages. This manual addresses the English version of the software.
STEP 4: Choose an IP configuration. There are three options:
○Fixed IP (Public IP or Virtual IP)
○DHCP (Dynamic IP)
○Dial-up (PPPoE)
STEP 5: Execute the IPScannerENG file.
Note: If a Windows Security Alert dialog box appears, choose the network type based on your monitoring environment, then press the
Allow access button. (Fig. 8)
Fig. 8 Windows Security Alert
STEP 6: Configure the IP Scanner software. (Fig. 9)
○The IP Scanner software searches for IP devices connected on the LAN. Choose Search Devices to refresh the search.
○Choose the desired IP device from the Device List on the left side of the IPSCanner menu box. The device becomes highlighted
when selected.
○Review the network configuration of the IP device, shown on the right side of the menu box. Customize the parameters of the
IP device, as desired, then press Submit.
Fig. 9 IPSCanner Menu Box

5
○Select OK to apply any changes and reboot the device. (Fig. 10)
Fig. 10 Rebooting Notification
STEP 7: Confirm the subnet of the PC IP address and the IP device IP address are the same.
Correct subnet configuration example Incorrect subnet configuration example
IP device IP address: 192.168.1.200 IP device IP address: 192.168.2.200
PC IP address: 192.168.1.100 PC IP address: 192.168.1.100
Fig. 11 IP Configuration Properties
○To update the PC IP address properties, follow the pathway: Control Panel èNetwork and Internet èNetwork Connections è
Local Area Connection Properties èInternet Protocol Version 6 (TCP/IPv6) èProperties. (Fig. 11)
STEP 8: Access the remote monitoring menu for the IP device by selecting the IP device from the Device list of the IPSCanner menu box and
pressing the left mouse button twice. A default network browser of the device control interface will open. (Fig. 12)
Fig. 12 IPSCanner Menu Box

6
STEP 9: To gain remote access, enter the default password admin for both the Username and Password. (Fig. 13)
Fig. 13 Remote Access Screen
Resetting to the Factory Default
Follow these steps to reset the CM2002 to default values.
STEP 1: Disconnect the power cord and Ethernet cable.
STEP 2: Locate the Default label on the CM2002. The default button is inside the hole located directly under the label. (Fig. 14)
Ethernet
PoE
DC 12V
In G Out G D+ D-
Ethernet
PoE
DC 12V
In G Out G D+ D-
Default
Fig. 14 Default button
STEP 3: Push the end of a paper clip into the hole to engage the button. Press and hold the button once the button is engaged. Do not
release the button.
STEP 4: Connect the power to the CM2002. The CM2002 automatically reboots. The reboot takes approximately 30 seconds.
STEP 5: Release the button the server is finished rebooting by removing the paper clip.
STEP 6: Plug in the Ethernet cable.
STEP 7: Log into theCM2002 using the default IP address (http://192.168.1.200), user name (admin), and password (admin).

7
Package contents
Video Server Installation Instructions CD (mini)
Ethernet
PoE
DC 12V
In G Out G D+ D-
Ethernet
PoE
DC 12V
In G Out G D+ D-
Default
CM2002
Digital I/O RCA/BNC
AC Adapter Connector Cable Assembly Velcro Pad Anchor Screws
Micro SD card Compatibility List
Micro SD Card Recommended:
Transcend SanDisk
SDHC class 4 16 GB SDHC class 4 8 GB
SD class 4 16 GB SDHC class 4 16 GB
SDHC class 4 32 GB SDHC class 4 32 GB
SD class 4 32 GB SDHC class 10 Max. 128 GB
SD class 6 4 GB
SDHC class 6 4 GB
SD class 6 8 GB
SDHC class 6 8 GB
SD class 6 16 GB
SDHC class 6 16 GB
SDHC class 10 4 GB
SDHC class 10 8 GB
SDHC class 10 16 GB
SDHC class 10 Max. 64 GB

8
CM2002 Specifications
Hardware
CPU Multimedia SoC
RAM 256 MB
Video In 1 in BNC Connector
Audio G.711 (64 K) and G.726 (32 K,24 K) audio
compression
Input : External Mic in
Output: External Audio out,
Support 2-way audio
I/O 1 DI/1 DO
RS-485 1 for PTZ control
Power Over Ethernet Yes
Operating Temperature Working Temperature: -20 °C~ 50 °C
(4 °F ~ 122 °F )
Power Consumption DC 12 V Max: 5 W
PoE Max: 802.3af, 5 W
Power output: : 12 VDC ( Max 400 mA )
Dimensions 50 mm x 27 mm x 97.9 mm
Weight 200 g
Network
Ethernet 10/100 Base-T
Network Protocol IPv6, IPv4, HTTP, HTTPS, SNMP, QoS/
DSCP, Access list, IEEE 802.1X, RTSP, TCP/
IP, UDP, SMTP, FTP, PPPoE, DHCP, DDNS,
NTP, UPnP, SAMBA, Bonjour
System
Video Resolution 1080P:
1920 x 1080 , 1280 x 720, 640 x 480,
320 x 240, 176 x 144
960H:
NTSC - 960 x 480, 704 x 480, 352 x 240,
176 x 144
PAL – 960 x 576, 704 x 576, 352 x 288,
176 x 144
760H:
NTSC - 720 x 480, 704 x 480, 352 x 240,
176 x 144
PAL – 720 x 576, 704 x 576, 352 x 288,
176 x 144
Video Adjust Brightness, Contrast, Hue, Saturation,
Sharpness
Triple Streaming Yes
Image Snapshot Yes
Full-Screen Monitoring Yes
Privacy Mask Yes, three different areas
Compression Format H.264/ M-JPEG
Video Bitrates Adjust CBR, VBR
Motion Detection Yes, three different areas
Triggered Action Mail, FTP, Save to SD Card, Samba, DO
Pre/Post Alarm Yes, configurable
Security Password protection, IP address filtering,
HTTPS encrypted data transmission,
802.1X port-based authentication for
network protection, QoS/DSCP
Firmware Upgrade HTTP mode, can be upgraded remotely
Simultaneous
Connection
Up to 10
Micro SD Card Management (Optional)
Recording Trigger Motion Detection, IP check, Network
breakdown (wire only),schedule, DI
Video Format AVI, JPEG
Video Playback Yes
Delete Files Yes
Wireless (Optional)
Wireless 802.11b/g/n
Security WEP, WPA-PSK, WPA2-PSK
Power Consumption DC 12 V Max: 6 W
Power output: 12 VDC ( Max 300 mA )
Web Browsing Requirement
OS Windows 7, XP, Microsoft IE 6.0 or above,
Safari, Firefox
Mobile Support iOS 8 or above, Android 4.0.4 or above
Hardware Suggested Intel Dual Core 2.8 G RAM, 4 GB,
Graphic card: 128 MB
Legrand reserves the right to change specifications without notice.

9
CM2002 Dimensions
Default
Video In
Audio
DO G DI G Out In
1.97 in.
(50 mm)
1.06 in.
(27 mm)
3.85 in.
(97.9 mm)
2.76 in.
(70 mm)

1507280 REV. A 20180306