LEHLE VOLUME BRACKET
INSTALLATION GUIDE for all LEHLE VOLUME edals
1
2
3 8
4
5
6
7
1 - Allen screw lus washer (2 cs)
2 - Bracket A
3 - Allen screw lus washer (2 cs)
4 - Bracket B
5 - Locking nut lus washer
6 - Allen screw lus washer (2 cs)
7 - Mounting late
8 - Bracket C
•Loosen Allen screws (1) and (3) so you can move
Bracket A and C. Do not remove screws, just turn
them counterclockwise a half-turn so they stay
attached to the brackets.
•Place the Volume Bracket onto your edal steel bar,
make sure the mounting late (7) touches the floor
and use the included Allen key to tighten the screws.
•Connect the ower su ly and cables to your Lehle
Mono Volume or Lehle Stereo Volume.
•Remove Allen screws (6). Place the edal onto the
Mounting late (7) so the holes of the edal match to
the holes on the late.
•Place the Allen screws lus washer (6) through the
mounting holes of the Volume edal and use the
Allen key to tighten them.
•By loosing and tightening the Locking nut (5) you can
adjust the angle of your edal.
Lehle GmbH · Grenzstraße 153 · D-46562 Voerde · Germany · www.lehle.com · su
[email protected]Co yright 2018 by Lehle · Page 2
