Lehmann electronic VarioRec 6 User manual

VARIOREC®
Radio Emergency Call Technology
Quick Reference Guide
VarioRec 6 Radio Receiver
Nurse call technologies and personal transmitter technologies
Phone.: [phone]
Fax.: [phone]
Lehmann Electronic GmbH Niederkassel
Copyright © 2019
LE235 V1.09 Page 1 von 2
www.lehmannweb.de
Warning
The use of a call device does not release supervisors from the obligation to supervise the persons supported by such a
device.
This system is radio-based and must therefore not be used for monitoring purposes if life-threatening conditions are
foreseeable. This quick reference guide does not release the user from the obligation to read and understand the contents
of the complete Variorec6 manual LE243, available on www.lehmannweb.de
Note: In this quick reference guide the “VarioRec6 radio receiver” is referred to as “radio receiver” or “receiver”.
This quick reference guide describes only the basic functions. It does not cover failures.
Starting the Radio Receiver and Receiving a Radio Call
Programming a Radio Transmitter
Before a radio receiver can detect a radio transmitter, the latter has to be programmed in the radio receiver.
*Press the right button while connecting the power supply unit.
4
1.5 s red
1
unitPlug in receiver
Receiver is
operational
2
Green
Receiver indicates and
transmits call
3
Supply
Power
Receiver is in
programming mode
2
Green
flashing light
Trigger
radio call
New radio
transmitter
has been detected
Briefly press
right-hand
button
5
The new radio
transmitter has
been programmed
6
1.5 s green
Press and hold
the left-hand
button
7
7
Receiver is
operational again
8
Green
3
Press and hold the right-hand
button when plugging
1
1.5 s red
4
1
Supply unit*
Power
Trigger
radio call
(transmitters already programmed)

VARIOREC®
Radio Emergency Call Technology
Quick Reference Guide
VarioRec 6 Radio Receiver
Nurse call technologies and personal transmitter technologies
Phone.: [phone]
Fax.: [phone]
Lehmann Electronic GmbH Niederkassel
Copyright © 2019
LE235 V1.09 Page 2 von 2
www.lehmannweb.de
Deleting a Radio Transmitter
A radio receiver ceases to detect a radio transmitter only after the latter has been deleted from the radio receiver.
Radio Receiver Messages
Important: These messages occur only in the operating state and indicate a fault / error. Acknowledge deletion of the
message. Please consult the complete manual LE 243 for detailed information on the respective message.
Message
Flash sequence
Measure
Acknowledge signal message
Transmitter battery
low
Red flashing light
Change radio
transmitter battery
Briefly press
left- or right-
hand button
No daily message
Green flashing
Check radio transmitter
Vital message
missing
Green/orange flashing
Looking for reason of
missing message
Reception blockage
Orange flashing
Check for sources of
radio
The message has been
deleted,
receiver is
operational again
System error
Green/red flashing
Error in radio receiver
or in the connection
Static call
Static light
Turn back the receiver
Briefly press
right-hand button
1
Press and hold the right-
hand button when plugging
Receiver
is in
programming
mode
Trigger a radio call
at the radio
transmitter to be
deleted
Radio transmitter
has been detected
5
Radio transmitter
has been deleted
1.5 s green
6
Green
flashing light
Green / red
flashing light
4
Press and hold
the left-hand
button
7
Receiver is
operational again
3
Green
3
Supply unit
Power
grün