Leica RINEX AgChem SP AutoSPRAY B User manual

AgChem SP
AutoSPRAY cable B
(Part No. 1-2817)
Installation Manual
Part Number: 1-1267
Revision: A
Issue Date: October 2008

1-1267 Rev A AgChem SP AutoSPRAY Cable B Installation Page 1
INTRODUCTION
The AgChem Self Propelled AutoSPRAY Cable B, optional cable, (Part
No: 1-2817) is designed to suit the following installations:
Compatible Vehicles
Rogator 1254 Rogator 1264 Rogator 1274
The cable will detect the status of the Master Switch and control the
seventh section of the boom if installed, but only if Cable A (Part
No 1-2816) is already installed.
The AgChem SP AutoSPRAY Cable A (Part No 1-2816) will control up
to six individual boom sections; it does not detect the status of the
Master Switch in the installation.
Figure 1: Cable A
(Part No 1-2816)
Figure 2: Cable B
(Part No 1-2817)

1-1267 Rev A AgChem SP AutoSPRAY Cable B Installation Page 2
INSTALLATION
A schematic of the cable and its relevant cabling to the installation is
shown in Figure 3.
Figure 3: Schematic layout Of typical AutoSPRAY installation
It is recommended that all electrical wiring should be
installed by a qualified auto-electrician. Incorrect wiring
may damage the AutoSPRAY controller and/ or the spray
rate controller.
The installation and configuration of the RINEX AutoSPRAY controller
is detailed in the appropriate User Manual.

1-1267 Rev A AgChem SP AutoSPRAY Cable B Installation Page 3
Step Instruction
1. Locate the wiring panel inside the cabin with the multi-
coloured wiring harness (Connectors-B) as shown in Figure
5.
2. Disconnect the mating connectors (B) as shown in Figure 5.
3. Plug the supplied optional cable in-line between the two
mating connectors from Step 2.
4. Connect the wires labeled "MASTER" and "SECTION 7" to the
supplied cable.
5. Confirm that the spray controller and boom section switches
function correctly.
Consult the AutoSPRAY controller installation manual to
setup and calibrate the AutoSPRAY system.
Figure 4
Figure 5
A
B