LEISUREWIZE LW642 User manual

LW642
Spin Dryer

2
Please read this manual carefully and take care of the following advice to avoid damages.
Any failure caused by ignoring the mentioned items and cautions mentioned in the
instruction manual are not covered by our warranty and any liability.
Safety Instructions
To reduce the risk o re, electric shock and damage:
•Do not expose this device to rain.
•Do not plac led with liquids, such as vases.
•Use recommended accessories only.
•Do not repair this device yourself. Refer repairs t ce personnel.
•Do not drop any metal objects into this unit.
•Do not place heavy objects on top of this unit.
Power cord / power supply
•Make sure that the power supply voltage corresponds t ations on this unit.
•Plug the power cord into the outlet securely.
•Do not pull, bend or place heavy objects on the power cord.
•Do not handle the plug with wet hands.
•Grasp the plug when pulling out of the electrical outlet.
•Do not use a damaged power plug or a damaged electrical outlet.
•Install this unit so that the power cord can be unplugged immediately if a problem occurs.
Small objects / Packaging Parts
Store small objects (e.g. screws and other mounting hardware) and packaging parts out of the reach of
children. Do not let children pla of su ocation!
Location
•Set the appliance on a dry at, waterproof and heat-resistant surface.
•The socket must be readily accessible to disconnect the unit quickly in an emergency.
•Do not install or position this unit in a conned space. Ensure good ventilation of the unit.
•Do not place near t other equipment that may be hot. The heat can damage the unit.
•Do not expose this unit to direct sunlight, high temperatures, excessive moisture or excessive vibration.
2
Please read this manual carefully and take care of the following advice to avoid damages.
Any failure caused by ignoring the mentioned items and cautions mentioned in the
instruction manual are not covered by our warranty and any liability.
Safety Instructions
To reduce the risk o re, electric shock and damage:
•Do not expose this device to rain.
•Do not plac led with liquids, such as vases.
•Use recommended accessories only.
•Do not repair this device yourself. Refer repairs t ce personnel.
•Do not drop any metal objects into this unit.
•Do not place heavy objects on top of this unit.
Power cord / power supply
•Make sure that the power supply voltage corresponds t ations on this unit.
•Plug the power cord into the outlet securely.
•Do not pull, bend or place heavy objects on the power cord.
•Do not handle the plug with wet hands.
•Grasp the plug when pulling out of the electrical outlet.
•Do not use a damaged power plug or a damaged electrical outlet.
•Install this unit so that the power cord can be unplugged immediately if a problem occurs.
Small objects / Packaging Parts
Store small objects (e.g. screws and other mounting hardware) and packaging parts out of the reach of
children. Do not let children pla of su ocation!
Location
•Set the appliance on a dry at, waterproof and heat-resistant surface.
•The socket must be readily accessible to disconnect the unit quickly in an emergency.
•Do not install or position this unit in a conned space. Ensure good ventilation of the unit.
•Do not place near t other equipment that may be hot. The heat can damage the unit.
•Do not expose this unit to direct sunlight, high temperatures, excessive moisture or excessive vibration.
Position this unit so that the power cord can be unplugged immediately if a problem occurs.
Please read and understand these instructions before any use of this product, and retain for
future reference
Do not let children play with plastic bags - risk of suocation!

3
Intended Use
•This device is used for drying clothing. It is exclusively meant for this purpose and must only be used for
this purpose. It may only be used in the manner as described in this manual.
•This product is not designed for use by persons (including children) who have reduced physical, sensory or
mental capacities or persons with no experience or knowledge, unless they are instructed and supervised in
the use of the appliance by a person responsible for their safety.
Transport
•Please keep the original packaging. To allow adequate protection during transport of the device, pack the
unit in the original packaging.
Cleaning
Do not use volatile liquids, such as insecticide spray. Do not clean the surface using high pressure as this can
cause damage. Rubber or plastic should not be left in contact with the device for any length of time. Clean
the appliance and the oor using a soft cloth and warm water, if necessary, a soap solution. Never submerge
the base in water or any other liquid.
Repairs
•Repairs to the appliance should only be carried out b
•
•Do not open or remove casing and attempt repairs yourself.
•Incorrect reassembly may result in malfunction or total failure.
•Opening, tampering or removing the casing of this product will void your warranty.
Do not clean the surface using high pressure as this can cause damage. Rubber or plastic should not be left in
contact with the device for any length of time. Clean the appliance and the oor using a soft cloth and warm
water, if necessary, a soap solution. Never submerge the base in water or any other liquid.
Repairs
• Repairs to the appliance should only be carried out by a qualied person.
• Any modication of this product will increase risk of damage and/or injury.
• Do not open or remove casing and attempt repairs yourself.
• Incorrect reassembly may result in malfunction or total failure.
• Opening, tampering or removing the casing of this product will void your warranty.

4
Product Description
0 Child lock
1 Lid fastener
2 Lid
3 Handles
4 Inner tub
5 Switch
6 Main body
7 Drain spout
8 Safety cover
9 Rubber feet
Use and Operation
Before rst Use
•Before using your spin dryer for the rst time, remove the foam inside the inner tub and clean inside with a
wet clean cloth and a non-polishing detergent.
•Remove the black, round motor locking device from the bottom of the unit. This prevents the motor from
moving around and potentially damaging the machine during shipping.
•Check to make sure your electric supply is 220-240V/50Hz and properly earthed.
•Plug in the machine and make sure it is properly connected to the power supply.
•With the switch handle (5) in the (0) position, open the lid(2).
•Place a container under the drain spout to catch the water. It is helpful to do this before loading the
clothes, as in some cases water can come out of the drain spout before operating the machine.

5
Removing the Motor Locking System
•Move the handle towards the position indicate by
the arrow.
•Remove the motor locking system.
How to properly load the Spin Dryer
•Load each article of clothing in an extended manner. The ligh-
test articles, such as socks, slops, handkerchiefs, etc. should be
put in the middle of the load.
•Try to prevent open spaces between items when loading the
clothes, as this can potentially cause an unbalanced load.
•After loading, insert the round safety Cover inside the inner
tub, on top of The clothes. Do not use an excessive amount of
force cover inside the inner tub on top of the clothes.
•The safety cover prevents clothes from leaving the inner tub
and potentially damaging the machine. Also, pressing down
on the clothes with the safety cover can help balance the load.
Operation
1.
Close the lid (2). Move the switch handle (5) to the on
position (1 ). The machine will start automatically.
2. Important: The spin dryer is equipped with a special safety feature, which pre -
vents you from moving the switch handle to the on position (1) while the lid (2) is
3. open. If the spin dryer starts shaking or moving, stop it by turning the switch
handle to the (0) position, balance the load and start again.
4. When the spin dryer starts, water will start owing out of the drain spout (7). Place
small container under the drain spout to catch the water. When water stops owing
out of the drain spout (normally in about 2-3 minutes, depending on the type of
clothes), you stop the machine by moving theswitch handle (5) to the (0) position.
5. Open the lid (2) when the inner tub (4) has come to a complete stop. The spin
dryer is equipped with a special electronic lock which does not allow the lid to
be lifted while the inner tub (4) is still spinning. Do not try to force it open before
it unlocks after 10 seconds time delay. The inner tub may spin very slowly for up
to around 10 seconds when plugged in, before you turn the machine. This is not
a product defect, nor does it present any safety issue due to the extremely low
speed. lt is due to a small amount of electricity stored in the capacitor.
Important: The spin dryer is equipped with a special safety feature, which prevents
you from moving the switch handle to the on position (1) while the lid (2) is open.
If the spin dryer starts shaking or moving, stop it by turning the switch handle to
the (0) position, balance the load and start again.
t
Important: The spin dryer is equipped with a special safety feature, which prevents
you from moving the switch handle to the on position (1) while the lid (2) is open.
If the spin dryer starts shaking or moving, stop it by turning the switch handle to
the (0) position, balance the load and start again.
t
How to properly load the Spin Dryer
• Load each article of clothing in an extended manner.
The lightest articles, such as socks, slops, handkerchiefs, etc.
should be put in the middle of the load.
• Try to prevent open spaces between items when loading the
clothes, as this can potentially cause an unbalanced load.
• After loading, insert the round safety Cover inside the inner tub,
on top of The clothes. Do not use an excessive amount of force
cover inside the inner tub on top of the clothes.
• The safety cover prevents clothes from leaving the inner tub and
potentially damaging the machine. Also, pressing down on the
clothes with the safety cover can help balance the load.

6
Cleaning and Care
• After using the spin dryer, unplug the power cord from the wall socket.
• Tilt the machine in the direction of the drain spout to remove any remaining water.
•To clean plastic and metal parts, such as the inner drum, use a non-polishing detergent. Do not use solvents, ke-
rosene, gasoline, etc. Do not wash the machine. Wrap the cord around the upper cover as indicated in the re.
• To carry or lift the machine, use the handles (3). Never lift it from the drain spout or power cord.
• Keep your spin dryer stored Indoors, in a clean, dry place.
Caution
• Never use extension cords without a earth wire.
• Before unplugging the spin dryer, always put the switch handle in the (0) position.
• Never unplug the machine by pulling the cord, always pull the plug.
• Always use under direct supervision. If you need to leave, st
• Never put footwear, back packs, teddy bears or similar items into the spin dryer.
• This appliance is not intended for use by persons (including children) with reduces physical, sensory or men-
tal capabilities, or lack of experience and knowledge. Unless they have been given supervision or instruction
concerning use of the appliance by a person responsible for their safety. Children should be supervised to
ensure that they do not play with this appliance.
• To avoid risk, be sure to replace the power cord by technicians from the manufacturer, their local mainte-
nance stores or similar parts if it is damaged.
Advice on Disposal
According to the European waste regulation 2002/96/EC this symbol on the product
or on its packaging indicates that this product may not be treated as household waste.
Instead it should be taken to the appropriate collection point for the recycling of electrical
and electronic equipment. By ensuring this product is disposed of correctly, you will help
prevent potential negative consequences for the environment and human health, which
could otherwise be caused by inappropriate waste handling of this product. For more de-
tailed information about recycling of this product, please contact your local council or your
household waste disposal service.
Streetwize Accessories:
Unit 1, Royce Trading Estate,
Ashburton Road West, Trafford Park,
Manchester M17 1RY
Sales enquiries:
[email protected]
Technical enquires:
[email protected]
Telephone: [phone]
www.streetwizeaccessories.com
To avoid risk always have parts replaced by a qualied technician
Never use extension cords without an earth wire.
To clean plastic and metal parts, such as the inner drum, use a non-polishing detergent. Do not use solvents,
kerosene, petrol, etc. Do not wash the machine. Wrap the cord around the upper cover for storage.
This appliance is not intended for use by persons (including children) with reduced physical, sensory or
mental capabilities, or lack of experience and knowledge. Unless they have been given instruction
For product support:
E: [email protected]
T: [phone]
For trade enquiries:
E: [email protected]
T: [phone]
Streetwize: Ashburton Road West,
Trafford Park, Manchester M17 1RY
www.streetwizeaccessories.com
EU Registered address: Ace Supply Co (Europe) Ltd. 25 Herbert Place, Dublin 2, D02 A098 Republic of Ireland.
• To avoid risk always have parts replaced by a qualied technician.
Caution