LEM 685 Operation instructions

USE AND MAINTENANCE INSTRUCTIONS
PLEASE READ BEFORE
OPERATING EQUIPMENT
COMMERCIAL FRENCH FRY CUTTER
Cat. #685
CARE:
1. Thoroughly wash and rinse the unit with hot soapy water before using.
2. For best results, do not put unit in dishwasher.
CAUTION:
1. The blades are very sharp. KEEP OUT OF REACH OF CHILDREN.
2. When cutting fibrous vegetables such as yams, sweet potatoes and onions, use the large blade.
Use a firm, quick, pushing motion to move the vegetables through the blades. Repeat as needed
until the produce is through the blade.
3. Toproduce the best strips, use fresh firm fruits and vegetables such as, carrots, cucumbers,
zucchini, apples, yams, sweet potatoes, onions, white, red, and yellow potatoes.
USE:
1. To change the blade, remove the three wing nuts on the front of the blade frame housing. It may
be necessaryto use a flat head screwdriver to release it from the face of the front stand.
2. Place the alternate blade on unit and replace the wing nuts.
3. Tochange the push plate, remove the four screws from the back of the push plate, and mount the
alternate plate in its place. Replace the four screws.
4. The unit can be mounted to a sturdy surface or to the wall.
PREPARING TO CUT FRUITS AND VEGETABLES:
1. DO NOT load the produce against the push plate. Push produce firmly against the blades
by hand. Once produce is slightly pierced by the blade proceed by pushing the handle down
to complete the cuts.

Commercial French FryCutter Parts List
Item No. Description Quantity
1 WING NUT 3
2 BLADE FRAME (COARSE) 1
3 BLADE FRAME (FINE) 1
4 PUSH PLATE (FINE) 1
5 PUSH PLATE (COARSE) 1
6 FRONT STAND 1
7 PUSH PLATE BASE 1
8 SCREW 4
9 CONNECTING SHAFT MOUNT 1
10 BOLT (M6) 2
Item No. Description Quantity
11 SCREW 2
12 CONNECTING SHAFT 2
13 HANDLE 1
14 ACORN NUT (M8) 3
15 BACK STAND 1
16 WASHER 1
17 CONNECTING ROD 3
18 STAINLESS STEEL BASE 1
19 ACORN NUT(M6) 2
20 BOLT (M8) 2
Cat. #685
L.E.M. Products, Inc.
107 May Drive, Harrison, OH 45030 • 877-536-7763 www.lemproducts.com
1YEAR WARRANTY COVERS PARTS AND LABOR ONLY.
RETURN FREIGHT IS THE RESPONSIBILITY OF THE PURCHASER.