9
www.lemo.com
Design and specifications are subject to change without notice.
Certifications and warranty
CE marking
CE marking means that the appliance or equipment
bearing it complies with the protection requirements
of one or several European safety directives.
FCC Compliance Statement
This device complies with Part 15 of the FCC Rules.
Operation is subject to the following two conditions:
1. This device may not cause harmful interference.
2. This device must accept any interference
received, including interference that may cause
undesired operation.
Note: This equipment has been tested and found
to comply with the limits for a Class B digital device,
pursuant to Part 15 of the FCC Rules.
These limits are designed to provide reasonable
protection against harmful interference in a
residential installation.
This equipment generates, uses and can radiate
radio frequency energy and, if not installed and used
in accordance with the instructions, may cause
harmful interference to radio communications.
However, there is no guarantee that interference will
not occur in a particular installation. If this equipment
does cause harmful interference to radio or
television reception, which can be determined by
turning the equipment off and on, the user is
encouraged to try to correct the interference by one
or more of the following measures:
• Reorient or relocate the receiving antenna.
• Increase the separation between the
equipment and receiver.
• Connect the equipment into an outlet on a
circuit different from that to which the receiver
is connected.
• Consult the dealer or an experienced
radio/television technician for help.
RoHS statement
LEMO products are in compliance with the RoHS
directives (2002/95/EC) of the European Parliament.
This directive specifies the restrictions of the use of
hazardous substances in electrical and electronic
equipment marketed in Europe.
LEMO guarantees that its connectors and media
converters are free of mercury, cadmium, lead,
hexavalent chromium and polybromide biphenyl
(PBB) or polybromide diphenyl ether (PBDE).
CAUTION Class 1 Laser Product
The MEERKATTM is classified as a CLASS 1 LASER
PRODUCT. Do not stare into the beam or view it
directly with optical instruments.
Recommendations
Do not paint your product. Always treat your
product with care and keep the fibre optic
connectors capped when not in use.
Cleaning Instructions
It is essential that the optical interface (ferrule end
faces) of the 3K.93C fibre optic contacts are clean
and free from any kind of debris to ensure the
correct performance and operation of the contact. It
is recommended that the inspection and cleaning
instructions provided by LEMO are used on the
3K.93C connector to ensure the connector
performs to the specified ratings.
Technical support
We understand you may have questions regarding
your new product. Should you require any
assistance, our technical support and customer
service is available to you. Whenever calling your
LEMO support, you will need to refer to the part
numbers located on the top the MEERKATTM unit.
Europe telephone: 0044 (0) 1903 222411
USA telephone: (+1 707) 578 88 11
Japan telephone: +81-3-5446-5510
China telephone: (86 21) 5899 7721
Warranty - 1 year
LEMO warrants this product to be free from defects
in design, material and workmanship under normal
use for the period of one (1) year from purchase
date.
If during the warranty period, this product should fail
under normal operation, LEMO will, at its option,
replace or repair the defective part.
This warranty does not include failure caused by
improper installation, operation, accident, improper
connection to peripherals, software or hardware
modifications outside of LEMO’s control.
Design and specifications are subject to change without notice.
