Lensen LS-V25000 User manual

Contact: Sunny Phone: [phone] Email：[e-mail]
LS-V25000 Radio Modem User Manual
LS-V25000 radio modem is a professional high performance data
transmission radio combining with newest RF chip and wireless
communication technology. This radio supports multiple frequency
band, VHF or UHF. With 25W power output, it has long transmission
distance which reaches about more than 20km in open air.
I: Features:
1. High power output: 10W or 25W
2. Long transmission distance: up to 20km
3. VHF band 150MHz band or 230MHz band or 450MHz
4. Data transmission, voice transmission both ok
5. Double PLL, double VCO, High reliability
6. VOX function
II. Data sheet
A、General Index

Contact: Sunny Phone: [phone] Email：[e-mail]
● frequency：VHF and UHF frequency band (150MHz, 230MHz), can
store about 400 channels
● frequency tolerance：±2.5ppm
● Channel spacing：25 KHz
● antenna impedance：50Ω
● environment temperature：-35 ℃~+75 ℃
● modulate mode：MSK
● air baud rate：1200bps/2400bps
B、Receiver Index
● sensitivity：≤0.25uV
● ignal Noise Ratio(SNR): ≤-50dB
● Adjacent Channel Selectivity: ≥70dB
● Inter modulation interference：≥70dB
● Spurious respouse immunity：≥70dB
C、Transmitter Index
● Transmit Power：25W
● modulate distortion：≤3%
● residual frequency modulation：≤-48dB
● frequency deviation：≤5KHz
● ortho-channel power ratio：≤-70dB
● stray power：≤5uW
● RF distance: 20km(25W RF power in the open air)
D、Power supply
● DC：12 V (±10%)
● waiting current：≤ 1 6 0 m A
● transmitting current：≤ 6 A ( transmit power 25W )
E、Dimension：
128*108*28mm
III. Pin Definition

Contact: Sunny Phone: [phone] Email：[e-mail]
Connector
Pin No.
Pin name
Description
Remarks
Power
connection
１
VCC
DC:12V
Please use power
DC 12V, more than 8A
２
GND
Ground of power supply
Signal
connection
１
NC
２
RXD（Ａ）
Rxd of RS-232
Rxd of TTL
RS-485 A
RS-232,RS-485,TTL,
only one valid
３
TXD（Ｂ）
TxD of RS-232
TxD of TTL
RS-485 B
RS-232,RS-485,TTL，
only one valid
４
NC
５
GND
Signal ground
６
PTT
Audio transmitting
enable
Low level is for
transmitting
７
MIC
Audio signal input
Microphone input，
modulation sensitivity
10mV
８
SP
Audio signal output
Audio amplifier output
8ohm 0.5W
９
SQ
Receiving signal
checking
Receiving carrier
signal, high level
IV: Application of LS-V25000
Salvage, Marine control
public traffic
industrial automatic control
electric power schedule
2 1
1 5

Contact: Sunny Phone: [phone] Email：[e-mail]
water conservancy monitor
signal collection and transmission of railway system
oil extraction and transportation control
measure of oil or water wells
hydrological monitoring
weather station monitoring
forest protection
intelligent building
geological reconnoiter
mobile location
military training
Notes:
1. About the power supply.
This radio's power output is high to 25W. 12V power D.C., at least 8A
is recommended to use. Please choose power D.C. with good
fluctuation coefficient and anti-interference ability. If you use switch
power supply, please keep the antenna far away from it to avoid
antenna's inference.
2. About the antenna.
Please choose antenna compatible with your radio's frequency band.
For long distance communication, directional and high gain antenna
would help to reach better effects. And also, please try to mount
antenna at higher level.
Antenna's and its cable's impedance should be accordance with
radio's (50Ω). If not, whole unit's performance will be affected and it
may damage the radio.
3. About antenna cable
Choose cable with 50 Ωimpedance and low decay material. Make
sure it can be connected with radio and antenna successfully. Please
also consider waterproof and lightning arrester.
4. Heat emission
If the radio needs to transmit for long time, please pay attention to
transfer heat in time.