LevelOne BOH-1200 User manual

- 1 -
BOH-1200
Outdoor Housing for Box Cameras w/ Infrared LEDs
Quic Installation Guide
CHECK YOUR PACKAGE CONTENT S
The carton should contain the following items:
 BOH-1200
 Camera bracket
 Screw kit
f any item is missing or damaged, please contact your local reseller for replacement.
Note: This installation should be completed by a qualified installer and should conform to all
local codes and regulations.
INTRODUCTION
The BOH-1200 is constructed from sturdy die cast aluminum with environmental protection
rated to P-66.
There is built-in fan and heater included. The fan operates when the temperature reaches over
35℃ and stops once the temperature stabilizes at 25℃ again.
The built-in heater begins operation once the temperature is under 15℃ and stops once the
temperature is over 25℃ again.
406mm(L) x 145mm (W) x 109mm (H)

- 2 -
ASSEMBLING THE MOUNTING BRACKET
Complete assembly by tightening the “E”
screw.
Connect the bracket by screwing in the 4 mounting screws on the bottom side of the housing.
INSID E THE HOUSI NG
1.
2. 5.
3. 4.
1. Protective light shield – prevents the R LEDs from reflecting into the camera’s lens.
2. Heater
3. Mounting brackets
4. Power relay board
5. Fan

- 3 -
Adjustable Mount ng Brackets:
1. First, attach Bracket A to your camera with the included mounting screws. (Note: Do not
tighten the screws 100% as you will need to make adjustments later.)
2. Next attach Bracket A + camera to Bracket B. Again, only tighten enough to hold in place
while deciding on the final position. Once the camera’s final position has been decided,
tighten all screws.
Power Relay Board: 4. 5.
3.
2.
1.
6.
1. DC12V/2.5A or AC24V/2.5A power input
2. AC24V power output for camera
3.
DC12V power output for camera
Bracket A
Bracket B
Horizontal 1 adjust
Horizontal 2 adjust
(optional)
Vertical adjust

- 4 -
4. Power supply to infrared LEDs
5.
Power supply to fan
6.
Power supply to heater
Note:
 AC and DC power can NOT operate simultaneously.
 Please note the difference between positi e and negati e terminals when connecting
power.

Default camera housing package don’t include power adapter

when use the optional power adapter to connect the P B of the housing , you have to cut adapter’s power
line to plug by manually