LevelOne FCS-8004 User manual

LevelOne
FCS-8004
4-Port Hybrid Capture Card
User Manual
Ver 1.0.0 - 0609

1
Table of Contents
Package Contents-------------------------------------------------------------------------P.2
System Requirements--------------------------------------------------------------------P.2
Physical Description---------------------------------------------------------------------- P.2
Install the FCS-8004 to your PC------------------------------------------------------P.3
Install the driver of FCS-8004----------------------------------------------------------P.4
Check DirectX version------------------------------------------------------------------- P.5
Install IP CamSecure--------------------------------------------------------------------- P.5

2
Package Contents
FCS-8004
Audio/Video Cables
CD Manual / Driver / Utility
Quick Installation Guide
System Requirements
FCS-8004
CPU Intel P4 2.4 GHz
RAM 512 MB
Mother-
board Intel 845 or 865 chip, Intel Chipset recommended
Display ATI Radeon 9200, nVIDIA GeForce FX-5200, Intel 845G/865G, or above
(ATI recommended)
Hard Disk 80 GB or above
OS MS Windows 2000 / XP
Physical Description
PCI Interface
VGA Connector

3
Install the FCS-8004 to your PC
Step1: Insert the card onto an empty PCI slot. Connect the Audio/Video cables to
the connectors in the same color.
Step 2: Turn on your PC and start Windows.
Connect the Audio/Video Cable
There are two audio and four video input connectors on the
Audio/Video Cable.
Connect the black cable to the black connector.
The audio input connectors of the black cable are with white wires
and marks of “Aud” on them; the video input connectors are with
black wires and the marks of “Vid”.

4
Install the driver of FCS-8004
Insert the included CD into CD-ROM.The setup page should load automatically. If
it does not, please select your CD-ROM drive manually to run autorun.exe.
Click”Install Software”
Click“Capture Card’s driver”
Click “Start” to install the driver
Click “Start” to install the driver

5
Click “OK” to complete the driver installation.
After driver being installed, please restart your PC.
Check DirectX version
Run dxdiag.exe from start menu ‘Start-> Run’ to check your DirectX version. If the
installed version is less than 9.0, install DirectX 9.0 from the CD-ROM directx9/
directory.
Install IP CamSecure
Click”Install Software”

6
Click”IP CamSecure”
Custom Setup Type:
You may install the system to the directory
of your preference and choose which
feature(s) you want to install to the PC.
Hint: You may, for instance, install only
Playback and/or LiveView on the PC at
home or other remote site from which you
do not install the camera but are going to
watch them remotely.