Levven Q User manual

Connecting Levven Q to your home network
Locate Levven Q in a central area of
the home where an electrical plug and
ethernet connection to your router are
available.
1. LOCATION
Insert the power supply cable into Levven
Q’s DC power input and plug the power
supply into a wall outlet.
2. POWER
Your other mobile devices connect to your
home network via Wi-Fi. Levven Q will need to
be on this same network.
Insert one end of the provided ethernet cable
into the network port on the back of Levven Q.
Connect the other end of the cable into a LAN
port on your home router (or an ethernet jack
connected to the router).
3. NETWORK

Connecting Levven Q to your home network
To confirm Levven Q has a connection to
the internet, the yellow and green indicator
lights on both sides of the ethernet outlet
of Levven Q will illuminate.
4. CONNECTION
Locate the blue Levven wall plate beside
the electrical panel. (Homes with the
electrical panel located outside of the
home will find the plate located in the
garage.)
5. WALL PLATE
Using the end of a pen, press and release
the ‘pairing’ button through the center
hole of the blue Levven wall plate. The LED
light will begin flashing green through the
smaller hole.
6. PAIRING

Connecting Levven Q to your home network
Press and release the pairing button on
the face of the Levven Q. Its LED will begin
flashing green.
7. PRESS BUTTON
Using the end of a pen, press and release
the ‘pairing’ button through the center of
the blue Levven wall plate to confirm the
pairing.
The LED will flash, confirming that Levven
Q has been paired to the group of electrical
load controllers in the home.
8. CONFIRM PAIRING
Open the next instruction guide and follow
the steps to download the Levven app and
connect your mobile device to Levven Q.
9. NEXT STEPS
CONTACT INFORMATION
Find full video guides and detailed technical
support at levven.com/support
Levven Electronics Ltd
9741 – 54 Ave NW
Edmonton, Alberta T6E 5J4
Canada
Levven Controls customer service:
[phone]
suppor[email protected]