LG 32LX3DC User manual

OWNER'S MANUAL
MODELS: 32LX3DC 132LX3DCS
Internet Home Page : http://_w'w.lgcommercial.com
Please read this manual carefully before operating your set.
Retain it for future reference.
Record model number and serial number of the set.
See the label attached on the back cover and quote
this information to your dealer
when you require service.
P/NO : 3828TUL309G (0508-REV02)
Printed in Korea

Warning
m
In
WAR N IN G
TO REDUCE THE RISK OF ELECTRIC SHOCK DO NOT REMOVE COVER (OR BACK). NO USER
SERVICEABLE PARTS INSIDE. REFER TO QUAUFIED SERVICE PERSONNEL.
_IL he lightning flash with arrowhead symbol, within an equilateral triangle, is intended to aJert the user to
the presence of uninsuIated "dangerous voltage" within the product's enclosure that may be of suffi_
cient magnitude to constitute a risk of electric shock to persons.
The exclamafJon point within an equi_ateta_ triangle is intended to alert the user to the presence of
important operating and maintenance (servicing) instructions in the literature accompanying the appD
ance_
NOTE TO CABL_V INSTALLER:
This reminder is provided to call the CATV system installer's attention to Article 820_40 of the National Electric
Code (USA) The code provides guidelines for proper grounding and, in particular, specifies that the cable
ground sha_ be connected to the grounding system of the building, as dose to the point of the cable entry as prac*
_caL
REGULATORY INFORMATION
This equipment has been tested and found to comply with the _imits for a Crass B digital device, pursuant to Pa_
15 of the FCC Rules. These limits are designed to provide reasonable protection against harmfu_ interference in
a residential installation. This equipment generates, uses and can radiate radio frequency energy and, if not
installed and used in accordance with the instructions, may cause har_ul interference to radio communications.
However, there is no guarantee that interference wilt not occur in a particular installation, if this equipment does
cause harmfuB interference to radio or television recep#an, _ich can be determined by turning the equipment off
and on, the user is encouraged to try to correct the interference by one or more of the following measures:
-Reorient or relocate the receiving antenna
increase the separatJon between the equipment and receiver.
* Connect the equipment into an outlet on a circuit different from that to which the receiver is connected.
Consult the dealer or an experienced radio/TV technician for help.
Any changes or modifications not expressly approved by the party responsible for compliance could void the
user's authority to oper_e the equipment
CAUTION:
Do not attempt to modify this product in any way without written authorization from LG Electronics Corporation
Unauthorized modification could void the users authority to operate this product,
U.S.A. only
COMPUANCE:
The responsible pa_ for this product's compliance is:
LG Electronics U.S.A., Inc.
1000 Sylvan Avenue, Englewood Cl_s, NJ 07632
Phone: [phone]_0
h_:ilwww.lgusa.cem
2

SafetyInstruction
Inst
WARNING •
To Reduce The Risk Of Fire Or E[ect_c _ock, Do Not Expose This Appara_s To Rain Or Moisture.
Apparatus shah not be exposed to dripping or splashing and no objects filted with liquid, such as vases, sh_l be pla_ on the
appara_&
IMPORTANT SAFETY INSTRUCTIONS
1. Read these instructions,
2, Keep these instructions
3, Heed all warnings
4_ Follow nit instructions°
5. Do not use this apparatus near water:
8. Do not in_ll near any heat sources such as radiators,
beat registers, stoves, or other apparatus (including
amplifiers) that produce heat,
9. Do not defeat the s_ety purpose of the polarized or
grounding type p_ug. A polarized ptug has two bEados
with one wider th_ the other. A grounding type plug has
two blades and a third grounding prong. The wide blade
or the third prong is provided for your safety. When the
provided plug does not fit into your outlet, consult an
electrician for replacement of the obsolete otYttet,
6, Clean only with a dry cloth_ 10, Protect the power cord from being walked on or
pinched particularly at plugs, convenience recepta-
cles, and the point where they exit from the apparatus,
7. Do not block _y of the ventilation openings. Install in
accordance with the manufacturer's instructions. il. Only use the attachments /acce_odes specified by
the manufacturer,
3

Sa[etyInstructions
Safety Instructions contin ued
12, Use only with a cart_ stand, tripod_ bracket, or table
specified by the manufacturer, or sold with the appa-
ratu& When a cart is used, use caution when _ving
the cart /apparatus combination to avoid injury from
tip-over.
13 Unplug this apparatus during lightning storms or when
unused for long periods of time
14, Refer _ servicing to qualified service personnel
Servicing is required when the apparatus has been
damaged in any way, such as power supply cord or
plug is damaged, liquid has bee# spilled or objects
have fallen into the apparatus, the apparatus has been
exposed to rain or moisture, does not operate normal-
ly, or has b_n dropped.
fNote
-ff the TV feels cold to the touch, there may _ a small "flicker" when when it is turned on. This is normal, there is noth-
ing wrong with TV_
-Some minute dot defects may be visible on the screen, appearing as tiny red, green, or blue spots. However, they have
no adverse effect on the monitor's performance
Avoid touching the LCD screen or holding your finger(s) against it for long periods of time Doing so may produce some
temporary distortion effects on the screen.
fCAUTION concerning the Power Cord
Most appliances recommend they be placed upon a dedicated circuit; that is_ a singte outiet circuit which powers only that
appliance and has no additional outtets or b_ch circuits. Check the specification page of this owne¢s m_uaU to be certain.
Do not overload wall out]eta. Ovedea_d wa_[ outlets, loose or damaged wail outlets, extension cor_, frayed power cords,
or damaged or cracked wire insulation are dangerous. Any of the_ conditions could resuff in electric shock or fire.
Periodically examine the cord of your appB_ce, and if its appearance indicates d_age or deterio_tJon, unplug it, discon _
tinue use of the app[iance_ and have the cord repiaced with an exact replacement part by an authorized servicer,
Protect the power cord from physicaJ or mechanical abuse, such as being twisted, kinked, pinched, closed in a door, or
walked upon. Pay particular atten_on to plug& wail o_tets_ and the point where the cord exits the appliance
Ii n Disposal i!
a. The fluorescent lamp used in this product contains a smalE a_unt of mercu_.
b. Do not dispose of this product with genera_ household waste.
Dispos_ of this product mu_ be _rried out in accor_nce to the regulations of your local authority.
4

2 Warnings
3~4 Safety Instru_ions
7 Controls
8 Connection Options
9~11 Remote Control Key Functions
14 Antenna Connection
15 External AV Source Setup
15 Digital Audio Ou_ut
16 VCR Setup
17 Cable _ Setup
18 DVD Setup
19 HDSTB Setup
20~21 PC Setup
22 Adjustments for screen Position, Clock, and Phase
22 fnitializing (Reset to original factory values)
23 Turning on the TV
23 Volu me Adj ustment
23 Channel Selection
23 On=screen Menus Language Selection
24 Screen Menus Selection and Adjustment
25 EZ Scan (Channel Search)
26 Channe_ Edit
27 DTV Signal Strength
27 Channel Label Setup
28 Main Picture Source Selection
28 Front Display
29 EZ Picture
29 Manuat Picture Control (EZ Picture_Off Option)
30 XD Function
30 Color Temperature Control
31 Video Preset
32 Audio Language
32 EZ SoundRit_
33 EZ Sound
33 Manuat Sound Control (EZ Sound-Off Option)
34 Stereo/SAP Broadcas_ Setup
34 Front Surround
35 TV Speakers On/Off Setup
5

_onter_t8
36 Auto Clock Setup
36 Manua_ Clock Setup
37 OnJOff Timer Setup
37 Steep Timer
38 Auto Off
39 Aspect Ratio Control
40 Caption
40 Caption Option
41 Caption Mode
42 Cinema Mode Setup
42 Demo (Review)
43 Split Zoom
_45 Parentaf Lock Setup
46 Watching PIP!Double Window
Selecting an input Signal Source for PIP/Double Window
46 TV Program Selection for PIP
47 Moving the PIP sub picture
47 Swapping PIP/Double Window
48~53
54
55~56
57~58
59
59
External Control Device Setup
Programming the Remote Control
Programming Codes
Troubleshooting Ch_klist
Maintenance
Product Specifications
6

|in
=This is a simplified representation of front panel.
o Here shown may be somewhat different from your TV,
Remote Control Sensor
/Power Standby Indicator
Illuminates red when the
TV is in standby mode,
illuminates green when the
TV is switched on.
ON/OFF Button
TW'v'I DEO Button
MENU Button
ENTER Button
VOLUME (_1,_) Buttons
CHANNEL (_r, A) Buttons
Ensure that the following accessories are included with your T'V. If any accessory is missing, please contact the
dealer from where you purchased the product.
Power Cord D-sub 15 pin Cable 6 Shietd Foams Polishing Cloth
Polish the screen with the cloth,
Owner's Manual Twister Holder
/Commerciai interface Control Box Manual Arrange the wires with the twister holder. Remote Control / AA Batteries
7

Introduction
Here shown may be somewhat different from your TV.
AUDIO Ir
COMPONENT2
('VIDEO input)
Power Cord Socket DIGITAL AUDIO OUTPUT DVI INPUT (PC/DTV INPUT)
/COMPONENT1iDVl INPUT * RJP INTERFACE
* PC INPUT2 S-VIDEO INPUT (For service)
(For service)
PC AUDIO INPUT1
PC INPUT1
/R8-232C INPUT (CONTROL/SERVICE)
ANTENNA INPUT
AUDIO/VIDEO INPUT1
* PC AUDIO iNPUT2 /SPEAKER OUT
(For service) COMPONENT1 (Y, PB, PR/AUDIO INPUT)
* For Serw'ce Jacks: PC IN,PUT2, PCAUDIO INPUT2, SPEAKER OUT and RJP INTERFACE
Be careful not to use this jack. Just contact your dealer or service center,
8

Introduction
Remote Control Key Functions
I!_uminatesthe remote controJ buttons.
Selects the _'emoteoperat!ng mode: TVI VCR, DVD, CABLE,
9

Introduction
CHANNEL UP/DOWN
Selects avaitaMe channels found with EZ scan
VOLUME UP/DOWN
increases!decreases the sound level
MUTE
Switches the sound on or off
SURF
Use to scroll the Surf channel list
INFO
When you watch the TV, displays information on top of the ._creen.
Not available in Component 1-2. RGB 1=2and DW mc_.
SAP
Selects MTS sound: Mono, Stereo and SAP. Change the
audio language in DTV mode. (Refer to p,34)
RATIO
Changes the aspect ratio, I Refer to p,39)
CC
Select a c{osed caption mode: Oil. CCI. CC2. CC3. CC4.
Textl, Text2, Text3, or Text4, (Refer to p,41)