CLEANING THE DUST TANK AND
FILTER ASSEMBLY
For best cleaning results, the dust tank
should be cleaned often.
1.Unplug cord from wall outlet.
2. Pull lid release out and up, then lift filter
cover
.
tank (27).
5. Wash the dust tank with sponge or soft
cloth under cold running water.
6. Brush (28) is for cleaning the filter
filter assembly.
7. Pull the filter supporter (29) down from the
supporter (29) with the brush under cold
running water.
Do not use detergent or wash in washing
machine or dishwasher.
supporter (29)to dry in shaded location for
a day.
Do not tumble or spin dry, nor microwave or
place in oven or in path of direct heat.
Ensure both the filter and filter supporter
are completely dry before placing it back into
the vacuum.
HOW TO FIT THE BAG MOUNT
AND THE DUST BAG
If you want to use a dust bag instead of
the dust tank, please:
1.Unplug cord from wall outlet.
2.Pull the cover release out and up, then
lift canister hood.
ensure the bosses on both sides of the
bag mount into the slots near the handle
on the base.
5.To fit a bag push the cardboard support
of a new bag into the bag mount until
it
will go no further
-7-
3. Pull the dust tank assembly (24) up.
4. Push the release lever (25) of the filter
assembly (26) and pull it out of the dust
assembly(26). It is on the back of the
filter assembly (26).
8.Clean the filter assembly 26) and the filter
9.Allow the filter assembly (26) and filter
3.Pull the dust tank assembly (24) up.
4.Fit the bag mount (19) with the spring,
