Liberta DISCOVERY User manual

A. front wire mesh
B. stand frame
C. connect piece
D.back frame
E.le&right wire mesh
It is recommended that two or three people assemble this cage
DISCOVERYAssembly Instructions
You should have:
All Assembly parts of DISCOVERY Cage Shown for your reference
N. Nut
O.ladder
P1.steel cup(small one)
P2.steel cup(big one)
T. wrench (screw all bolts)
G. top frame
H1.le u tube
H2.right u tube
I.perch stand of top
J1. top Perch (length)
J2. Perch (short)
K1. boom grill
K2. top grill
L. top&boom tray
M1 .screw (dia=6mm L=35mm)
M2. screw (dia=6mm L=40mm)
M3.screw (dia=6mm L=10mm)
E
*2
D
*1
Q. cup holder on top
R.handle of feeder door
S. feeder cup holder
U. hexagon wrench

Step 1
to be connue...
E
*2
D
*1
Step 2
M1
M1
M1
M1
Screw C and B with
M1(posion as
drawing);then connect B
and A with 5 of M1 at
boom posion
Insert D into the hole of B,and
screw with M1(posion as
close-up); then put grill K1
onto B(as drawing), slide 2 of
E into B along with chutes of A
and D

Step 3 Step 4
*5
M2
N
M1
Fix H1 and H2
onto G with 4 of
M2 and nut N;
insert D into hole
of G and screw by
M1(as close-up);
screw the other
end of G with 4 of
M1
Connect I and H1&H2 with 2 of
M1; put K2 and 2 of L into the
drawing posion

Step 5 Step 6
Insert Q into the holes of
J,and put P1 on it; insert O
into J and A as drawing; Put
J1 on J.
Fix 2 of S onto the feeder
door separately, then screw
them with 4 of M3 and 2 of
R (posion as drawing).Put 2
of P2 on S;
Finished Cage!
outer close-up
inner close-up
P*4
P2