LIBERTY AV SOLUTIONS DIGITALINX DL-ILFO-H2 User manual

11675 Ridgeline Drive
Colorado Springs, CO
80921
Rev 200921 Phone: [phone]
Toll-Free: 800-530-8998
Fax: [phone]
DL-ILFO-H2 Install Guide

DL-ILFO-H2 Owners Manual
3
The DigitaLinx DL-ILFO-H2 HDMI 2.0 extender set extends uncompressed HDMI audio and video up to 200m
/ 660’ using a duplex mul-mode OM3 ber cable. The DL-ILFO-H2 Supports HDMI 2.0b up to 18Gbps, CEC,
HDR10, HDR10+ Dolby Vision and HDCP 2.2 as well as High Denion Dolby and DTS audio formats.
The DL-ILFO-H2 is sold only as a set. The individual transmier and receiver are not compable with other ber
extender oerings unless specically noted otherwise.
Product Overview
Package Contents
• (1) Transmier (Tx) and One (1) Receiver (Rx)
• (2) Micro USB to USB power cables
• (1) Installaon Guide
• (2) 5V 1A power supply with US, AU, EU and UK adapters

DL-ILFO-H2 Owners Manual
4
Installaon Instrucons
Connect the DL-ILFO-H2 transmier and receivers USB port to the supplied power supplies and connect to
a local power source. The DL-ILFO-H2 transmier can be powered by 5V from pin #18 of the HDMI interface
however the receiver must receive a constant power supply @ 5V/1A, some TV’s and projectors may be able
to supply this power via a USB A port but if the power supplied by the TV is not stable or sucient enough, it
is recommended to use the provided power supplies on each extender device. Always the check the available
USB power on a TV to be sure the receiver will receive the correct amount of voltage and amperage if using this
method.
NOTE: Digitalinx recommends using both USB power supplies connected to both transmier and receiver for a
stable power connecon and supply.
When power is supplied the power LED will turn ON.
Connect Power
Connect Fiber Cables to Extenders
Connect a duplex LC OM3 opcal ber cable between the transmier and the receiver, note that each ber
channel should be connected as (A) to (A) and (B) to (B) respecvely.
The maximum length for the OM3 ber cable is 200m / 660’. This extender will not work with single mode ber
cable for longer distances.
NOTE: Digitalinx does not recommend or support cable interrupts or pass-throughs in the ber cable such as
keystone plates or patch panels, this may cause undesired interrupons in system performance.

DL-ILFO-H2 Owners Manual
5
Connect the DL-ILFO-H2 transmier to the HDMI source, connect the receiver to the TV display.
NOTE: Be sure the extender device labeled TRANSMITTER is connected to the HDMI source, and the device
labeled RECEIVER is connected to the TV display.
When a successful audio and video link has been established between the HDMI source / transmier and TV
display / receiver the STATUS light on the extender devices will blink.
Connect Fiber Extender to Devices
HDMI SOURCE DISPLAY
DL-ILFO-H2
TRANSMITTER
OM3 Fiber up to
200m / 660’
USB Power
USB Power
DL-ILFO-H2
RECEIVER

DL-ILFO-H2 Owners Manual
6
Technical Specicaons
Supported Audio and Video
Video Compliance HDMI 2.0b, HDCP 2.2, and CEC (Consumer Electronics Control)
Input / Output Resoluon Support All resoluons are supported up to 4096x2160 / 60Hz; 4:4:4; 8 bit deep color
Maximum Pixel Clock 600MHz
Embedded Audio LPCM, Dolby Digital/Plus/EX, Dolby True HD, DTS, DTS-EX, DTS-96/24,
DTS High Res, DTS-HD Master Audio, DSD
Fiber Opc Signal Characteriscs
Maximum Distance 200 meters / 660’ feet
Required Cable Type Duplex LC-LC OM3
Bandwidth 18Gbps
Chassis and Environmental
Dimensions (W*H*D) 26 mm (1 in) x 15 mm (0.6 in) x 72 mm (2.8 in)
Operang Temperature (Environment) 0 to + 50°C (32 to + 122 °F)
Operang Temperature (Storage) -30 to +70°C (-22 to + 158 °F)
Operang Humidity (Environment) 10% to 85%, Non-condensing
Product Weight 175g / .4 lbs
Power
Maximum Power Consumpon 5 was
Power Supply Input Voltage AC 100-240V, 50/60Hz.
Power Supply Output Voltage DC +5 V, 1A
Regulatory CE, FCC, RoHS
Other
Standard Warranty 5 Years
Included Items (1) Transmier, (1) Receiver, (1) Install Guide, (2) DC 5V Power Supply with
US, UK, EU and AU power adapters (2) USB Micro to A power cables

Thank you for your purchase.
For Technical Support please call our toll free number at
800-530-8998 or email us at [e-mail]
www.libav.com
Digitalinx is a brand of:
11675 Ridgeline Drive
Colorado Springs, Colorado
80921 USA
Phone: [phone]
Fax: [phone]
Toll-Free: 800-530-8998