Liberty Pumps K002012 User manual

Kit Installation Instructions
Grinder Stand
Copyright © Liberty Pumps, Inc. 2023 All rights reserved. 7000 Apple Tree Avenue Bergen, NY 14416 1-800-543-2550 www.LibertyPumps.com
1359000B
for Ordinary and Hazardous Location Omnivore®models
(X)LSG and (X)LSGX-Series
(X)LGV02 and (X)LGH02-Series
Kit #K002012 Contents
• (4) Set Screws
• (4) Stand Base Bushings
• (2) Omnivore Wire Stands
• (4) Socket Head Cap Screws (7/8” length)
• (4) Socket Head Cap Screws (1-1/8” length)
Note: Two sets of fasteners are included in the
kit, but only one set will be used.
Shorter screws (7/8” length) are for use with
single-stage pumps
Longer screws (1-1/8” length) are for use with
2-stage pumps.
1. Remove two screws from the grinder cutter
plate.
Single-stage grinders will have socket head
cap screws with a 3/16” Allen wrench drive.
2-stage grinders will have hex head cap
screws with an 11 mm drive head.

2 | EN Copyright © Liberty Pumps, Inc. 2023 All rights reserved. 1359000B
2. Install two bushings with the supplied socket
head cap screws (3/16” drive).
Note: When tightening the screw, ensure that
the set screw hole is facing away from the
pump centerline.
3. Slip the wire stand into both bushings,
ensuring it is completely seated in the
bushing.
Install the supplied set screws in the tapped
holes with a 3/32” Allen wrench.
4. Repeat these steps on the opposite side of the
pump.