Life Fitness Pro 9000 Series User manual

M051-K50-A123 1
2 STACK MULTI-JUNGLE (SM20)
UNPACKING AND ASSEMBLY INSTRUCTIONS

SM20 Unpacking & Assembly Instructions
2
The SM20 comes partially assembled. Follow the steps below to complete the assembly.
WARNING: COMPONENTS OF THE SM20 ARE LARGE AND HEAVY. USE CAUTION
WHEN ASSEMBLING THIS MACHINE.
MATERIALS AND TOOLS REQUIRED FOR ASSEMBLY
9/16”
Socket wrench with
extension
9/16”
Combination
wrench
Pinch bar
You will also need a ladder.
ASSEMBLY TIME
Two people can accomplish this assembly in approximately 1/2 hour.
UNPACKING
Follow the steps below when unpacking the components of the SM20.
1. Cut off the shipping wrapper.
2. Remove the parts box and shipping boards.
3. Remove the items in the parts box.

SM20 Unpacking & Assembly Instructions
3
ASSEMBLY
Figure 1 shows an assembled SM20.
Figure 1. SM20 main components (cables removed for clarity).
1. 1 stack cell (2)
2. Connecting beam
1. Place the two weight “cells” in their final resting spots. The cells will be
approximately 11’4” apart as shown in Figure 2.
Figure 2. Set the weight stack cells.

SM20 Unpacking & Assembly Instructions
4
3. Bolt on the connecting beam using a 5/8” socket with extension and combination wrench, to
the cells using the four 7/16” x 6” bolts, 7/16” washers, and 7/16” nuts, end cap washers and
end caps. Figure 3 shows the connected cells. You may wish to use a pinch bar to align the
bolt holes.
Figure 3. Bolt on the connecting beam.
Figure 4. Configuration for 6” bolts.

SM20 Unpacking & Assembly Instructions
5
CROSSOVER CABLE ROUTING
NOTE: THE INFORMATION BELOW IS FOR REFERENCE ONLY. THE
CABLES ON THE SM20 HAVE BEEN INSTALLED AT THE
FACTORY.
Figure 5. Crossover cable routing.

SM20 Unpacking & Assembly Instructions
6
Figure 8. Screw the pulley into the weight stack.

SM20 Unpacking & Assembly Instructions
7
HARDWARE
Hardware Figure 1. Assembly Parts.
The parts shown in Hardware Figure 1 are used to assemble the SM20. They are:
A. 7/16” x 6” hex head bolt (used to bolt connecting beam to the tops of the cells)
B. 7/16” flat washer
C. 7/16” cap washer (use on head end of the 6” bolt so end cap will fit on the nut)
D. 7/16” hex head nut
E. End caps (bolt covers)
PARTS LIST
Part # ID Description Quantity
Main components
1
21-stack cell
Connecting beam 2 1
0017-00101-1561
0017-00104-0363
0017-00104-0366
0017-00103-0233
0017-00042-0969
6” bolt hardware
A
B
C
D
E
7/16” x 6” hex head bolt
7/16” flat washer
7/16” cap washer
7/16” Nyloc nut
End caps
4
4
4
4
4
Handle and bar
hardware Safety carabiner
Crossover handle
Leg strap
2
2
1