As soon as you unplug the mains adapter, the blood
pressure monitor loses the date and time setting but the
saved measurements are retained.
Display Setup and Memory Deletion
It is essential to set the date and time.
Otherwise, you will not be able to save your measured
values correctly with a date and time and access them
again later.
• Before initial use and after each time you replace the
battery: When inserting batteries into the device, you will
be taken to the relevant menu automatically.
• If the batteries have already been inserted: Press and
hold the settings button SET on the device when
switched off for approx. 3 seconds. Enter into the setup
interface, the content of setup will be displayed by
flashing. Press the SET button, it will enter into the switch
of setup content:
“memory deletion -> talking function -> year -> month
-> day -> hour -> minute.”
• Press memory button to revise setup value.
• Press ON/OFF button to store the setup content.
Note: This monitor displays one unit mmHg.
Cuff Connection
Insert the air tube plug into the socket by revolving it.
If the low battery indicator is permanently displayed,
you can no longer perform any measurements and must
replace the batteries. Once the batteries have been
removed from the device, the time must be set again.
Battery disposal
• The empty, completely flat batteries must be disposed
of through specially designated collection boxes,
recycling points or electronics retailers. You are legally
required to dispose of the batteries.
Operation with the mains adapter
You can also operate this device with a mains adapter.
When doing so, there must not be any batteries in the
battery compartment.
• To prevent possible damage to the device, the blood
pressure monitor must only be used with the mains
adapter described here.
• Insert the mains adapter into the connection provided
for this purpose on the blood pressure monitor. The
mains adapter must only be connected to the mains
voltage that is specified on the type plate.
• Then insert the mains plug of the mains adapter into the
mains socket.
• After using the blood pressure monitor, unplug the
mains adapter from the mains socket first and then
disconnect it from the blood pressure monitor.
9
