Lift Tech Marine HYDRAULIC User manual

HYDRAULIC
Control Panel
The control panel will go into a sleep mode and the lights will turn off after 2 minutes of
not being used. Press any button to wake it up and the lights will come back on.
REMOTE CONTROLS
The two blue remote controls that come with the unit are already paired. To pair
another remote control, press the lock and “hidden” key buttons down together on
the front of the control panel for 1 - 2 seconds. Then press any button on the remote
control. Do the same thing to pair another remote control.
Website:
Go to www.lifttechmarine.com for more information, troubleshooting and how to
videos.
The hydraulic control panel works the
same as the remote controls.
Press UP to go up and DN to go down.
Press the light button to turn the canopy
light on or off.
Press the lock / unlock button for 5
seconds to lock the control panel. Press
it again for 5 seconds to unlock the
control panel. When the control panel
is locked the STATUS LED and READY
LED will blink together.
When plugged into power the READY
light will be a solid green. The STATUS
light will blink red and the Bluetooth
symbol will blink blue. When you pair a
phone through bluetooth the light will be
a solid blue and no longer ash.

IOS Guide For
Hydraulic Control
3. After you have activated the bluetooth sequence
look at your phone and Tap the button in
the upper right hand corner of app. (See pic 2)
LiftTechRX should now appear like in (pic 3). Tap
it and the screen should now look like (pic 4). Now
tap on the pair option. *For security reasons you
will have about 30 seconds to complete.
4. Once paired and connected to a Lift Tech
receiver, the screen similar to (pic 5), will show the
remote control options.
5. UP..... Tapping and holding this button will raise the lift.
DOWN....Tapping and holding this button will lower the lift.
LIGHT..... Tapping this button will turn your canopy light on or off.
LOCK..... Hold for 5 seconds to lock or unlock the control panel.
NOTE: When done operating the lift, for security and IOS battery purposes, it
is advised to disconnect from the Lift Tech receiver. To do this tap <disconnect
in the upper left corner to be returned to the screen shown in pic 3.
1. Go to the App store and search for Lift
Tech and download the app. Once the
app is downloaded on your phone, open
the app and continue.
2. To activate the Bluetooth pairing
sequence press the UP and DN buttons
on the control panel at the same time
then release. (See picture below).

ANDROID Guide For
Hydraulic Control
5. Press on the Lift - Signal Strength that comes up
on the phone to pair it.
6. Once the phone is paired it will look like PIC 3.
You are now done pairing your phone with the
control panel.If you want to rename your lift simply
press the rename tab on the top right of the app
and a box will come up like in PIC 4. Rename it to
what you want and hit Rename to save it.
7. UP..... Tapping and holding this button will raise the lift.
DOWN....Tapping and holding this button will lower the lift.
LIGHT..... Tapping this button will turn your canopy light on or off.
LOCK..... Hold for 5 seconds to lock or unlock the control panel.
1. Go to Google Play and search for Lift Tech Marine and download the app.
Once installed open the app.
2. To activate the Bluetooth pairing sequence press the UP and DN buttons
on the control panel at the same time then release. (See picture below).
3. Press the scan button on the top right of your phone. (See PIC 1)
4. When the phone nds the motor it will look like PIC 2.
PIC 1 PIC 2 PIC 3 PIC 4