Page 3
V 1.5
... ...
P1P2
P8 P7 P5 P3 P1
GND
P6 P4 P2
www.lightrider.com
Light Rider WiFi & USB-DMX Interface Ref. LR512
© Nicolaudie Group 1989-2019. All rights reserved. We reserve the right without notice to amend the technical information and specications.
Technical datasheet Revision date 26 June 2019
Computer Software (Windows/Mac) - Single Zone
http://www.store.dmxsoft.com
Purchase licences for additional Nicolaudie Group computer DMX software
Hardware Manager (Windows/Mac/iPhone/iPad) - Firmware, clock..
https://storage.googleapis.com/nicolaudie-eu-tools/Release/HardwareManager.exe
https://storage.googleapis.com/nicolaudie-eu-tools/Release/HardwareManager.dmg
The iPhone/iPad version can be found on the app store
The controller can be connected directly from a computer/
smartphone/tablet (Access Point Mode), or it can be connected to
an existing local network (Client Mode). The controller will work in
Access Point (AP) Mode by default. See Programming the Controller
for further information
• In AP Mode, the default network name is Smart DMX Interface
XXXXXX where X is the serial number. For serial numbers below
179001 the default password is 00000000. For serial numbers
above 179000 the default password is smartdmx0000
• In Client Mode, the controller is set, by default, to get an IP
address from the router via DHCP. If the network is not working
with DHCP, a manual IP address and subnet mask can be set. If
the network has a lewall enabled, allow port 2430
The controller can be connected to an existing automation system
over a network and triggered via UDP packets on port 2430. Refer
to the remote protocol document for more information.
The controller can be upgraded at store.dmxsoft.com. Hardware
features may be unlocked and software upgrades may be purchased
without the need to return the controller.
Dry Contact Port Triggering
Network Control
UDP Triggering
Upgrades
It is possible to start scenes using the input ports (contact closure).
To activate a port, a brief contact of at least 1/25 second must be
established between the ports (1...8) and the ground (GND) using the
external HE10 connector. Note: the scene will not be switched o
when the switch is released.
The controller can be programmed from a PC, Mac, Tablet or Smartphone using the software available on our website. Refer to
the corresponding software manual for more information. The rmware can be updated using the Hardware Manager which is
included with the programming software and also available on the App Store.
Programming the Controller
Setting up the Controller
Easy Remote Pro
Create an entirely customized remote controller for your tablet
or smartphone. Easy Remote is a powerful and intuitive app
allowing you to easily add buttons, faders, color wheels and
more. Connect to a WiFi network and the app will nd all
compatible devices. Available for iOS and Android.
Arcolis
The Arcolis application is a comprehensive tool allowing you
to directly control and re-program the controller from your
smartphone or tablet. This is a simple application which can
be used by just about everyone in any situation. Mobile, easy
to use and powerful, Arcolis is the ideal controller for dimming
or switching traditional, LED and RGB color mixing DMX
lighting xtures. Program static and dynamic lighting scenes
and eects. Currently available for Android only.
Light Rider
Designed for live use, moving and color eects can be
created automatically to create an automated light show.
iPhone/iPad/Android Control
Service
Servicable parts include:
• DMX Chips - used to drive the DMX (see p2.)
