Lightolier VP Parabolic DZA1G16MS140 User manual

VP PARABOLIC DZA1G16MS140
Page 1 of 2 1’ x 4’ RECESSED FLUORESCENT 16 CELL PARABOLIC LOUVER
STATIC AND AIR SUPPLY/RETURN IES RP24 PREFERRED
Job Information Type:
Job Name:
Cat. No.:
Lamp(s):
Volts/Ballast:
Lightolier a Genlyte Thomas Company www.lightolier.com
Technical Information: [phone] • Fax [phone]
631 Airport Road, Fall River, MA 02720 • [phone] • Fax [phone]
We reserve the right to change details of design, materials and finish.
© 2002 Genlyte Thomas Group LLC (Lightolier Division)
A0902 Section 2/Folio G09-25
Features
• Meets IES RP-24 Preferred Practice.
• Ideal for intensive VDT use area.
• Only 5.5” deep.
• Utilizes CFI Advance Technology Reflector Louver.
• Faceplate made with die-formed 20 gauge steel with edges hemmed for
rigidity.
• Full length air slots with bent edge for rigidity.
• Precise fitting reflector louver.
• Louver securely held with CFI concealed torsiontite spring clips
• Fixture Efficiency 62.4%

VP PARABOLIC DZA1G16MS140
Page 2 of 2 1’ x 4’ RECESSED FLUORESCENT 16 CELL PARABOLIC LOUVER
STATIC AND AIR SUPPLY/RETURN IES RP24 PREFERRED
Lightolier a Genlyte Thomas Company www.lightolier.com
Technical Information: [phone] • Fax [phone]
631 Airport Road, Fall River, MA 02720 • [phone] • Fax [phone]
We reserve the right to change details of design, materials and finish.
© 2002 Genlyte Thomas Group LLC (Lightolier Division)
A0902 Section 2/Folio G09-25
Job Information Type:
Specifications
PERFORMANCE: In an installation of 2 lamp 32W luminaires in a room cavity
ratio of 1 reflectance 80% ceiling, 50% wall, 20% floor the C.U. shall no be less
than 0.69. To prevent glare the VCP shall not be less than 88 either lenghtwise
or crosswise (at 100 fc level) and that the average luminance will conform with
the IES RP-24 preferred standard, and have a fixture efficiency of not less than
60%.
MATERIALS: Chassis parts are die formed 22 gauge cold rolled steel. Faceplate
is die formed 20 gauge cold rolled steel with edges hemmed for rigidity.
LOUVER: Post-anodized aluminum.
FINISH: Louver - Low iridescense specular postanodized vertical grain sheet or
Low iridescence reflector matte post-anodized vertical grain sheet. Chassis
exterior - white baked polyester powder coat.
Specifications (continued)
ELECTRICAL: Rapid start HPF thermally protected class “P” ballast CBM certi-
fied by ETL if K.O. is within 3” of ballast use wire suitable for at least 90°.
LABELS: Listed by CSA/UL.
ORDERING INFORMATION Explanation of Catalog Number. Example: DZA1G16MS140120OC