Lightolier LUPS Series User manual

LUPS Series
550-1,500 VA UNINTERRUPTIBLE POWER SUPPLY
Page 1 of 2
Job Information Type:
Job Name:
Cat. No.:
Notes:
LUPS550A
16.6"
(42.16 cm)
39.0"
(99.06 cm)
Overall Characteristics
Features: 82-86% throughput
efficiency. Single conversion
UPS, no transfer time.
Operating temperature range
of 32°F (0°C) to 104°F (40°C);
65°F (19°C) to 85°F (30°C)
for batteries. Standard 90
minutes of operating time, 10
and 20 minute operating times
available. Full-time, isolating
transformer. Variable range
regulator allows wider range
of acceptable input voltage
variation. ANSI/IEEE C62.41
category A & B surge voltage
withstand capability.
Application: Operates
incandescent, electronic ballast
loads and HID lighting loads as
well as critical loads requiring
conditioned emergency power.
Housing: Free standing,
NEMA 1 enclosure with
locking doors and acid-
resistant powder coat finish.
Multiple conduit entries
available.
Battery: Maintenance free,
sealed lead calcium battery
with an expected life up to 10
years, and optimum operating
range of 65°F (19°C) to 85°F
(30°C).
Input: Input power factor
is self-correcting to > 0.95.
Frequency range 60.0 Hz ± 2.5
Hz. Input voltage tolerance is
+10% to -15%. Input harmonics
is < 8% THD.
Output: Solid state PWM
inverter with sine wave output.
Output voltage regulation is
±3% of nominal at full load.
Output frequency is 60 Hz
+ 0.2%. Load power factor
capability is 0.6 lagging to unity.
Overload rating is 125% for 10
minutes.
Charger: Low voltage
disconnect (LVD). Recharge
time is UL 924 compliant.
Standard Metering/
Controls: AC input and
output voltage, AC input
breaker, and AC output
breaker. Battery disconnect
device and automatic battery
monitor with alarm. LED
indicating lamps for system on
utility, system on battery, and
low battery warning.
Code Compliance
UL 924 and UL 924 auxiliary
equipment listed.
Warranty
One year electronics warranty.
One year full, nine years
pro-rata battery warranty.
Extended warranty options
available.
31.0"
(78.74 cm)

LUPS Series
550-1,500 VA UNINTERRUPTIBLE POWER SUPPLY
Page 2 of 2
Philips Lightolier
e: [email protected]
t: [phone]
w: www.lightolier.com
LUPS Series September 2, 2011
Specifications are subject to change without notice.
© Koninklijke Philips Electronics N.V., 2011.All rights reserved.
Job Information Type:
Ordering Information
System One-Line Diagram
Series
LUPS = LUPS Uninterruptible Power
Supply for Emergency Lighting Applications,
90 Min. Backup
LUPSX = 10 Min. Backup
LUPSY = 20 Min. Backup
Voltage Configuration
A= 120 V Input/Output
B= 277 V Input/Output
550 = 550 VA
1000 = 1,000 VA
1500 = 1,500 VA
VA Rating
O
ptional
O
utput
Circuit Breakers
OCB1 = 550 VA
OCB3 = 1,000, 1,500 VA
Factory Installed
O
ptions
FSU = Start-Up Service
EXT = Extended Warranty1
Note
1) EXT option only available with FSU.
Output Power
to Load
Ferroresonant
Transformer
T1
Double
Primary
Double
Primary
Solid State
Line Switch
S1
InverterCharger
Utility AC
Power In
AC AC
DC
DC
P1
P2
MODEL
LUPS550
LUPS1000
LUPS1500
CAPACITY
550 VA
1,000 VA
1,500 VA
AC INPUT
VOLTAGES
120
277
120
277
120
277
INPUT
AMPS1
6.5
2.8
11.5
5.0
17.2
7.4
AVAILABLE OUTPUT
VOLTAGES/MAX LOAD AMPS
BREAKERS
INCLUDED
1
1
3
3
3
3
Input (select one)
120 V
4.6
8.3
12.5
277V
2.0
3.6
5.4
Output (select one)
CABINET &
ELECTRONICS
SEALED LEAD
CALCIUM
BATTERY
10 Min Backup
20 Min Backup
90 Min Backup
550 VA
223 lbs
(101.0 kg)
44 lbs
(19.9 kg)
54 lbs
(24.5 kg)
121 lbs
(55.0 kg)
1000 VA
223 lbs
(101.0 kg)
59 lbs
(26.8 kg)
88 lbs
(39.9 kg)
203 lbs
(92.0 kg)
1500 VA
262 lbs
(119.0 kg)
88 lbs
(39.9 kg)
108 lbs
(49.0 kg)
288 lbs
(131.0 kg)
Note
1) Maximum input current.
HEAT
REJECTION
(BTU/HR)
410
545
615
System Input/Output Ratings