Lightspeed Redcat Acess User manual

Good placement
Best place
avoid!
Quick StartGuide
DETERMINE SET-UP LOCATION AND PLUG IN POWER SUPPLY
ment
The Redcat Access can be set up on a cabinet or table-
top. If is it desired to be installed on a wall, please refer
to the User Manual.
Insert the DC connector into the DC INPUT on
the RCA and plug the other end into an electri-
cal output
POSITION THE FLEXMIKE AROUND
YOUR NECK AND POWER ON
Turn the microphone on using the
ON/OFF button on the top of the
Flexmike. This will automatically turn
on the Redcat Access. When taking the
Flexmike off of the charging cable, it
will automatically power on and default
to mute (red LED).
ADJUST VOLUME AS NECESSARY
Microphone volume may be adjusted using the
UP/DOWN buttons on the side of the Flexmike.
RE G I ST
ER
AU D I O
IN
MIN
M
A
X
AUDIO
(AL D )
OU T
MIN
M
A
X
ON/OF
F
DC
INPUT
16V/2.0
A

ADJUST TONE ASNECESSARY
If further fine-tuning is required, you may need to adjust the
Tone Control on the top of the Redcat Access
OUTPUTTOASSISTIVELISTENING
DEVICE
Connect a patch cable from the personal ALD’s microphone
jack or AUX input to the 3.5mm audio jack labeled “ALD
OUT’ on the side panel. Adjust volume as necessary.
USE FLEXMIKE AS A WIRELESS
AUDIO LINK
Plug your external audio equipment
(for example, laptop), into the
input jack on the Flexmike labeled
“INPUT” using a 3.5mm patch
cable.
CHARGE FLEXMIKE NIGHTLY.
Plug the micro USB end of the charging cable into
the USB port on the bottom of the Flexmike. When
Flexmike is fully charged, the LED on the mic will
change to green.
Lightspeed Technologies
GKP Global Solutions Inc.
www.gkpglobalsolutions.com
QS0472US01-0
1
2
MICROPHONE
TON
E
MI
N
MAX
TREBLE
BAS
S
VOLUME
REGISTER
AUDIO IN
MIN
MAX
AUDIO
(ALD)
OUT
MIN
MAX
ON/OF
F
DC
INPUT
16V/2.0A