Lincat Silverlink 600 GS6 User guide

IS 215 ECN 4399 Page 1 of 8
Installation, Operating and Servicing
Instructions
Silverlink 600 Electric Griddles
GS3, GS4, GS6, GS65, GS7, GS9
And all derivatives
Please make a note of your product details for
future use:
Date Purchased:_________________________
Model Number:__________________________
Serial Number:__________________________
Dealer:_________________________________
_______________________________________

IS 215 ECN 4399 Page 2 of 8
CONTENTS
Important Information
2
Warnings and Precautions
3
Technical Data
3
Checklist of Enclosures
3
Installation and Commissioning
3-5
Operating Instructions
5
Cleaning
5-6
Servicing, Maintenance and Component Replacement
6
Fault Finding
6
Spare Parts List
6-7
Accessories
7
Service Information and Guarantee
8
IMPORTANT INFORMATION
Read these instructions carefully before using this product, paying particular
attention to all sections that carry warning symbols, caution symbols and notices.
Ensure that these are understood at all times.
WARNING!
This symbol is used whenever there is a risk of personal injury.
CAUTION!
This symbol is used whenever there is a risk of damaging your Lincat product.
NOTE:
This symbol is used to provide additional information, hints and tips.
KEEP THIS MANUAL FOR FUTURE REFERENCE

IS 215 ECN 4399 Page 3 of 8
WARNINGS AND PRECAUTIONS
This appliance must be installed, commissioned and serviced by a qualified person
in accordance with national and local regulations in force in the country of
installation.
If the supply cord is damaged, it must be replaced by the manufacturer, its service
agent or similarly qualified person.
Ensure that the plug/socket is accessible at all times.
Strip plastic coating and clean the appliance before use.
During operation parts may become hot - avoid accidental contact.
Disconnect this appliance before servicing, maintenance or cleaning.
TECHNICAL DATA
Model
Height mm)
Width (mm)
Depth (mm)
Weight (kg)
GS3
330
300
600
24
GS4
450
40
GS6
600
50
GS65
600
50
GS7
750
61
GS9
900
93
CHECK LIST OF ENCLOSURES
Warranty card
Instructions manual
INSTALLATION AND COMMISSIONING
This appliance must be earthed.
An equipotential bonding terminal is provided to allow cross bonding with other
equipment.

IS 215 ECN 4399 Page 4 of 8
If replacing the plug connect the terminals as follows:
Green and Yellow wire Earth E
Blue wire Neutral N
Brown wire Live L
Means of isolation with at least 3mm contact separation in all poles must be
incorporated into the fixed wiring of this appliance.
The fixed wiring insulation must be protected by insulated sleeving having a
temperature rating of 600C.
Supply cords shall be oil resistant, sheathed flexible cable not lighter than ordinary
polychloroprene or equivalent elastomer sheathed cord (code 60245 IEC 57)
Install this appliance on a level surface ensuring all vents are unobstructed. Any
partitions, walls or furniture must be of non-combustible material. Minimum
distances A 100mm B 1000mm –see Fig 1.
Fig 1

IS 215 ECN 4399 Page 5 of 8
Power Ratings
Model
kW
Supply 1N~+E
Supply 3N~+E
GS3
2.0
8.7
N/A
GS3/E
2.5
10.9
N/A
GS4
2.7
11.7
N/A
GS6
3.0
13.0
N/A
GS4/E
3.7
16.1
N/A
GS6/T
4.0
18.0
L1 9 L2 9 L3 N/A
GS6/T/E/NORWAY
5.6
N/A
L1 12.2 L2 12.2 L3 21.5
GS65
4.5
19.6
N/A
GS6/E
5.6
24.4
L1 12.2 L2 12.2 L3 N/A
GS7
6.0
26.0
L1 13 L2 13 L3 N/A
GS7/E
7.0
30.4
L1 10.2 L2 10.2 L3 10.2
GS7/E/NORWAY
7.0
N/A
L1 18 L2 18 L3 18
GS9
8.6
37.0
L1 12 L2 12 L3 13
GS9/NORWAY
8.6
N/A
L1 20 L2 20 L3 20
Models of 3kW and less are supplied with a fitted plug and lead. Models over 3kW
must be installed by a qualified electrician. (Note: GS4/E is supplied with a Euro
plug and lead).
OPERATING INSTRUCTIONS
Only qualified or trained personnel should use this appliance.
Before using the appliance for the first time, wipe the protective oil off the griddle
plate and wash it down with mild detergent solution.
Please note: It is important not to leave the steel plate surface uncoated for any
length of time. Once these steps have been followed, the plate must be coated with
a thin film of cooking oil as instructed below in the ‘Cleaning’ section.
Connect to the power supply and switch on –the green neon indicates power to the
appliance.
The temperature in each half of twin zone models may be controlled separately.
Turn the control knobs to the required setting –the amber neon illuminates.
The griddle is ready to use when the amber neon extinguishes. The amber neon
will then operate as the element cycles.
Regularly check the fat drawer. Do not let it overflow.
CLEANING
Do not use a water jet or steam cleaner, and do not immerse this appliance.

IS 215 ECN 4399 Page 6 of 8
Clean outer panels with warm water and mild detergent, do not use abrasive
materials. Dry with a soft cloth.
Cleaning of griddle plates
All griddle plates may be cleaned with a proprietary food safe cleaner.
Do not use ice to clean the plates.
Steel plates
Allow to cool. Scrape off any residue and wash down with mild detergent and
water.
Rinse to remove all traces of detergent. Once clean and dry, protect with a light
coating of cooking oil.
Chrome plates
Remove food debris during use when possible.
Allow to cool, flush with water to soften any residue.
Use a bristled brush to loosen debris, and scrape it into the fat drawer.
Repeat the flushing process, adding a little mild detergent. Rinse and wipe dry with
a soft cloth.
Do not use sharp instruments on a chrome surface.
SERVICING, MAINTENANCE AND
COMPONENT REPLACEMENT
All servicing, maintenance and component replacement on this appliance should be
carried out by one of our recommended service engineers.
Please refer to the Service Help Desk number on the final page of this manual.
FAULT FINDING

IS 215 ECN 4399 Page 7 of 8
Part Number
Description
Used on
CO09
Relay
GS65
CO215
Contactor
GS9
EL104
Element
GS3, GS3C, GS6/T, GS6/TR, GS6/TFR
EL105
Element
GS4, GS4C
EL106
Element
GS6, GS6C
EL107
Element
GS65
EL108
Element –3kW
GS7, GS7C, GS7/R, GS9,
(GS9/NORWAY RH ONLY)
EL155
Element –2.8kW
GS6/T/E, GS6/T/E/NORWAY, GS6/TR/E,
GS6/TR/E/NORWAY, GS6C/T/E,
GS6TFR/E, GS9, (GS9/NORWAY LH,
CENTRE ONLY)
EL156
Element –3.7kW
GS4/E, GS4C/E
EL160
Element –2.5kW
GS3/E, GS3C/E
EL194
Element 2.33kW LH
GS7/E, GS7/E/NORWAY, GS7C/E,
GS7R/E
EL195
Element 2.33kW Centre
GS7/E, GS7/E/NORWAY, GS7C/E,
GS7R/E
EL196
Element 2.33kW RH
GS7/E, GS7/E/NORWAY, GS7C/E,
GS7R/E
FE37
Foot
All
KN182
Control knob
All
NE42
Amber neon
All
NE43
Green neon
All
PL201
Mains cable
GS3, GS3C
PL202
Mains cable
GS3/E, GS4, GS4C, GS6, GS6C
PL203
Mains cable
GS3C/E
TE45
3 phase terminal
All other models not using PL201, PL202,
PL203
TH107
Thermostat
All
Part Number
Description
Used on
SB3
Splash guard extension
300 wide models
SB4
450 wide models
SB6
600 wide models
SB7
750 wide models
SB9
900 wide model
SPARE PARTS LIST
ACCESSORIES

IS 215 ECN 4399 Page 8 of 8
For help with the installation, maintenance and use of your Lincat equipment,
please contact our service department:
UK: 01522 875520
For non-UK customers, please contact your local Lincat dealer
All service work, other than routine cleaning should be carried out by one of our
authorised service agents. We cannot accept responsibility for work carried out by
other persons.
To ensure your service enquiry is handled as efficiently as possible, please tell us:
Brief details of the problem
Product code
All available on serial plate
Type number
Serial number
Lincat reserve the right to carry out any work under warranty, given reasonable
access to the appliance, during normal working hours, Monday to Friday, 08:30 to
17:00.
GUARANTEE
This unit carries a comprehensive UK mainland 2 year warranty. The guarantee is
in addition to, and does not diminish your statutory or legal rights.
The guarantee does not cover:
Accidental damage, misuse or use not in accordance with the manufacturer’s
instructions
Consumable items (such as filters, glass, bulbs, slot toaster elements and door
seals.)
Damage due to incorrect installation, modification, unauthorised service work or
damage due to scale, food debris build-up, etc.
The manufacturer disclaims any liability for incidental, or consequential damages.
Attendance is based on reasonable access to the appliance to allow the authorised
technician to carry out the warranty work.
Service calls to equipment under warranty will be carried out in accordance with the
conditions of sale. Unless otherwise specified, a maximum of 15 minutes of
administrative time, not spent directly carrying out servicing work, is provided for
within the warranty. Any requirement for staff attending the call to spend greater time
than 15 minutes due to administrative requirements, such as on health and safety risk
assessments, will be chargeable at the prevailing rate.
SERVICE INFORMATION