Lingo FYQ-I User manual

Model: FYQ-I

User’s Guide
APPEARANCE:
GETTING STARTED:

1. Open the box and take out the LI GO, and charge the LI GO until blue light is on.
2. ow install the App to your mobile device:
i. IOS: Open the App Store and search to install “Lingo Saturn Tech”
ii. Android: Open the Play Store and search to install “Lingo Saturn Tech”
3. After the installation is completed, the Lingo Saturn Tech App will appear on your mobile device.
1) Initial first time set up: Press on/off button until the RED light is on, and wait for about a minute until you see both BLUE and RED lights
flash repeatedly. Then open the LI GO app and choose the WiFi network and enter the password. Then select your “Source Language”
and “Target Language”. Press “SE D” and you will hear a dialing tone in a few seconds. Once connected, the “Green” Light will turn on
solid, LI GO is now ready to use.
2) After the initial set up is completed the first time, you will OT need to set up every time you turn on LI GO.
4. When you turn on the device, the “Red” light will turn on solid, wait for about a minute and the “Green” light will turn on solid
automatically

5. Primary User: Tap once on the “Source Language” button and the light will turn “Blue”, speak your source language and when done the light will
turn “Green” again. LI GO will translate to the preset target language.
6. Receiver User: Tap once on the “Target Language” button and the light will turn “Blue”, speak in the preset target language and when done the
light will turn “Green” again. LI GO will translated to the preset source language.
FCC Certification Information:
This device complies with part 15 of the FCC Rules. Operation is subject to the following two conditions:
(1) This device may not cause harmful interference, and
(2) This device must accept any interference received, including interference that may cause undesired operation.
Changes or modifications not expressly approved by the party responsible for compliance could void your authority to operate the equipment.
FCC Applicant: Saturn Technology Group, LLC.
2664-B Saturn St., Brea, Ca. 92821
RF Exposure Information (SAR)
This device has been designed and manufactured to comply with the limits for exposure to RF energy set by the Federal Communications
Commission (FCC) of the United States and other countries.
The exposure standards for wireless devices employ a unit of measurement known as the Specific Absorption Rate, or SAR. The SAR limit set by the
FCC/IC is 1.6W/kg averaged over 1 gram of tissue. The SAR limit recommended by The Council of the European Union is 2.0W/kg averaged over any
10 grams of tissue. The highest reported SAR value are 0.926 mW/g for body.
The FCC have granted an Equipment Authorization for this device with all reported SAR levels evaluated as in compliance with the FCC RF exposure
guidelines. SAR information on this device is on file with the FCC, and can be found under the Display Grant section of www.fcc.gov/oet/ea/fccid
after searching on FCC ID: 2AOA5CCCC0217002.
This device is in compliance with SAR for general population/uncontrolled exposure limits in A SI/IEEE C95.1-1999 and has been tested in
accordance with the measurement methods and procedures specified in KDB 865664 D01.
Thank you again for your purchase of our Product.
©2017 Saturn Technology Group, LLC.