Link electronics PAV-880 User manual

MADE IN THE USA
LINK ELECTRONICS, INC.
BLACK BURST, TONE & VIDEO/AUDIO DA
MODEL PAV-880
FEATURES
6 Black Burst Outputs
Tone Generator
1 X 8 or two 1 X 4 Video
1 X 8 Mono or 1 X 4 Stereo
The PAV-880 provides the user with six precision
black burst outputs for system distribution. Its stable
internaltimebaseprovidesflawlessoutputsignalsfor
black burst reference, factory adjusted to RS-170A
standards. Black burst is provided on rear panel
BNC connectors. In addition, a high quality 1 KHz
tone generator is provided for audio system testing.
A rear panel terminal block allows for easy
connection to the system. The balanced, low
impedance output conforms to Audio Engineering
Society (AES) standards for audio distribution.
The video DA section has high impedance loop
through in the 1X8 mode of operation. In the dual
1X4 mode, the input is terminated internally. The
dualmodeofoperationprovidesfouroutputsofeach
of the two inputs. A switch on the rear panel allows
the unit to operate as a dual 1X4 DA with two
terminated inputs with four outputs each amplifier
section.
Twogain controls onthefront panel adjustthe video
level to ±3dB for each set of four outputs. The video
bandwidth is 20 MHZ, making it a very useful device
for any application. A fuse on the front panel
provides easy replacement.
The audio DA section has high impedance loop
through. All connections for the inputs and outputs
use positive captive screw clamp terminals blocks
locatedonthe rearpanel.Aswitchonthe frontpanel
allows the unit to operate as a mono or stereo DA
with one input and eight outputs mono or 2 X 4
stereo. Selecting the dual 1 X 4 mode is required for
stereo operation with four outputs for each of the
Left and Right channels. A Master Gain Control on
the front panel adjust the audio gain to ±16dB. A
gain trim control for each channel allows for
independent level adjustment. A balanced match of
each channel is easily obtained.
LINKELECTRONICS, INC. 2137 Rust Avenue Cape Girardeau, MO 63703-7668
Phone [phone] FAX [phone]

PAV-880 REAR PANEL
MODEL PAV-880 BLACKBURST & A/V DA
SPECIFICATIONS
BLACK BURST OUTPUTS: OUTPUTS, VIDEO SECTION: continued
Number: ............................Six Frequency Response: .......... -3dBat.17Hz
Standard: ................. NTSC,RS-170A ±0.1dB to 14MHz
Sync:.................. -40IRE, 0.286Vpp -0.3dB at 16MHz
Pedestal: ................7.5IRE,0.054Vpp -3dB at 20MHz
Burst:.................. 40IRE(0.286Vpp) Output Isolation: ........... >36dB at 3.58MHz
Connectors: ........................ BNC DCOffset ...........................<2mV
Impedance: .................75Ohms+1% LineRateTilt:....................... <0.1%
Timebase Stability: .............. ±0.0005% Field Rate Tilt: ...................... <0.1%
...........-10to+60°Cat14.318180MHz RMS Hum, 20MHz Filtered: ............ >60dB
Tilt & Overshoot: ................... <0.5% RMSNoise,20MHzFiltered: ........... >60dB
SyncRiseTime: ..............140nS ±20ns
Pedestal Rise Time: ...........140nS ±20ns INPUT, AUDIO SECTION:
Burst Envelope: ...............350nS ±15ns Maximum Level: ....................+50dBm
S/NRatio: ........................ >55db Impedance: ..................>10KΩbridging
Residual Subcarrier: .................<2mV CMRRatio:.................. -80dB at 60Hz
Maximum Common Mode Range: ........ ±10V
TONE OUTPUT:
Number: ........................... One OUTPUTS, AUDIO SECTION:
Configuration: ..... Balanced,LowImpedance Number:
Level:........................ 0dBm±1% 1X8: ................................ 8
Frequency: .................. 1kHz±1Hz 2X4:.................... 4,eachamplifier
Connector: .......... PositiveCaptureScrew MaximumLevel: ......... +24dBm @150 ohms
Impedance: .................... 66Ω±5% ....................+26dBm @ 600 ohms
THD: ...................... Approx.0.2% Impedance: ........................... 44Ω
S/NRatio: ........................ >80dB Frequency Response: . . . ±0.1 dB, DC to 20 KHz
Isolation Between Outs: .... >70dB DC to 20KHz
INPUT, VIDEO SECTION: Gain Range: ........................ ±16dB
Video Level: ................ 1.0Vpp±3dB Signal To Noise: ............>-90dB, unity gain
Impedance: Total Harmonic Dist.(THD): . . . <0.2% @ +17dBm
1 X 8 Mode: .......... 100K ohms bridging DC to 20KHz with max. Ioads, Max Gain
2 X 4 Mode: ............. 75Ωterminating Inter-Mod.Dist.(lMD):....4:1<0.02%@+22dBm
Maximum DC on Inputs: ............. 4VDC ............................+10dB Gain
Common Mode Range: .............. 8Vp-p CrossTalk:.............. <65dB, 20 to 20KHz
CMRR: DC Offset: ............<50mVPhaseToPhase
60Hz: .......................... >90dB
30KHz:......................... >70dB ENVIRONMENTAL:
1MHZ:......................... >45dB Temperature: .............0°to50°Cambient
CrossTalk: ....................... >60dB Humidity: ........ 10%to90%non-condensing
OUTPUTS, VIDEO SECTION: Power: ............................4watts
Number: AC Voltage: ............120/240VAC50/60 Hz
1X8:................................. 8
2X4:.........................4eachDA MECHANICAL:
Level:.....................Unitygain±3dB Height: ........................ 1.75inches
Impedance: ......75Ω±1%sourceterminated Width: .......................... 19Inches
Propagation Delay: ..................12nS Depth:......................... 11.5Inches
DifferentialGain: ................... 0.15% Weight:........................ 4.5Pounds
DifferentialPhase:................... 0.12°
LINKELECTRONICS, INC. 2137 Rust Avenue Cape Girardeau, MO 63703-7668
Phone [phone] FAX [phone]