
Wireless Regulatory Information
1
Wireless Regulatory Information
FCC Statement
This device complies with Part 15 of the FCC Rules
Operation is
subject to the following two conditions: (1) This
device may not cause
harmful interference, and (2) this
device must accept any interference
received, including
interference that may cause undesired operation
This product has been tested and complies with the
specifications
for a Class B digital device, pursuant to Part
15 of the FCC Rules
These
limits are designed to provide reasonable protection against harmful
interference in a residential installation
This equipment generates,
uses, and can radiate radio frequency energy and, if not installed and
used according to the instructions, may cause harmful interference
to radio communications
However, there is no guarantee that
interference will not occur in a particular installation
If this equipment
does
cause harmful interference to radio or television reception,
which is
found by turning the equipment off and on, the user is encouraged to
try to correct the interference by
one or more of the following
measures:
•
Reorient or relocate the receiving antenna
•
Increase the separation between the equipment
and devices
•
Connect the equipment to an outlet other than the receiver’s
•
Consult a dealer or an experienced radio/TV technician
for
assistance
FCCCaution
: Any changes or modifications not expressly approved by the
party responsible for compliance could
void the user’s authority to
operate this equipment
2
4GHz
operation
o
f
this
pr
oduct
in
the
US
A
is
firmwar
e-
limited to
channels 1 through 11
The device for the band 5150-5250 MHz is only for indoor usage to reduce
the potential for harmful interference to
co-channel mobile satellite
systems
FCC Radiation Exposure Statement
This equipment complies with FCC radiation exposure limits set forth
for an uncontrolled environment
This
equipment should be installed
and operated with minimum
distance 35 cm between the radiator and
your body
This device and it’s antennas(s) must not be co-located
or operating in
conjunction with any other antenna or transmitter except in
accordance with FCC multi- transmitter product procedures
Innovation, Science and Economic Development Canada
Statement
CAN ICES-3 (B)/NMB-3 (B)
This device contains licence-exempt transmitter(s)/ receiver(s) that
comply with Innovation, Science and
Economic Development
Canada’s licence-exempt
RSS(s)
Operation is subject to the following two
conditions: (1)
This device may not cause interference,
and (2) this device must
accept any interference, including interference that may cause
undesired operation of the device
For product available in the USA/Canada market, only
channel 1~11
can be operated
Selection of other channels
is not possible
The device could automatically discontinue transmission in
case of absence
of information to transmit, or operational
failure
Note that this is not
intended to prohibit
transmission of control or signaling information or
the use
of repetitive codes where required by the technology
The maximum antenna gain permitted for devices in
the band 5725-5850 MHz shall be such that the
equipment still complies with the e i r p limits
specified for point-to-point and non-point-to-point
operation as appropriate
le gain maximal d’antenne permis (pour les
dispositifs utilisant la bande 5725-5850 MHz)
doit se conformer à la limite de p i r e spécifiée pour l’exploitation
point à point et non point à point, selon le cas
Innovation, Science and Economic Development Canada
Radiation Exposure Statement
This equipment complies with ISED radiation exposure
limits set forth
for an uncontrolled environment
This
equipment should be installed
and operated with minimum
distance 35 cm between the radiator & your
body
This device and it’s antennas(s) must not be co-located
or operating in
conjunction with any other antenna or transmitter except in
accordance with ISED multi- transmitter product procedures
Restrictions in the 5 GHz Band
The device for the band 5150-5250 MHz is only for indoor usage to reduce
potential for harmful interference to co-
channel mobile satellite
systems
This device has been designed to operate with an antenna having
a
maximum
gain
o
f
2
53
dBi
and
3
37
dBi
at
2
4
GHz and 5 GHz
respectively
Antenna having a higher gain is strictly prohibited per
regulations of ISED
The required
antenna impedance is 50 ohms
The maximum antenna gain (Please see the table below)
permitted (for
devices in the bands 5250-5350 MHz and 5470-5725 MHz) to comply
with the EIRP limit and
because high power radars are allocated as
primary users
(meaning they have priority) in 5250-5350 MHz and
5650-5850 MHz, these radars could cause interference
and/or
damage to license exempt LAN devices
No.
Antenna
Type
Gain (dBi)
For 5 GHz Gain
(dBi)
Antenna
Connector
1
Dipole
2
52
3
37
I-PEX
2
Dipole
2
53 3
28
I-PEX
Additional requirements for the band
5600-5650 MHz
Until further notice, devices subject to this Section
shall not be capable of transmitting in the band 5600-
5650 MHz, so that Environment Canada weather radars
operating in this band are protected